INSTRUCTION MANUAL PORTABLE RADIO CASSETTE RECORDER WITH CD PLAYER PRC-241 PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL: (02) 9313 7111 FAX: (02) 9313 7555 www.palsonic.com.
SAFETY INSTRUCTIONS WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN The lightning flash and arrow head within the triangle is a warning sign alerting you of "dangerous voltage" inside the product. The exclamation point within the triangle is a warning sign alerting you of important instructions accompanying the product.
13. Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. 14. Damage Requiring Service - The appliance should be serviced by qualified service personnel when: A. The power supply cord or the plug has been damaged; or B. Objects have fallen, or liquid has been spilled into the appliance; or C. The appliance has been exposed to rain; or D.
. .. ON CONDENSATION When left in a healed room where it is warm and damp, water droplets or condensation may form inside the unit. When there is condensation inside the unit, the unit may not function normally. Let it stands for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit before use. Should any trouble occurs, remove the power source and refer servicing to qualified personnel FUNCTION AND CONTROLS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12.
POWER SOURCE A. BATTERY OPERATION 1 Remove the Battery Door (#32). 2 Following the polarity diagram as shown on the Battery Door (#32) insert 8 x "D" size (UM-1) batteries (not included) IMPORTANT: Be sure that the batteries are installed correctly. Wrong polarity may damage the unit. 3. 4. 5. 6. For better performance and longer operating time, we recommend the use of alkaline-type batteries. Do not mix old and new batteries.
CD PROGRAMMED PLAY This function allows the tracks to be played in a programmed sequence. 1. Press the Program Button (#21) once. The CD Program Indicator (#27) will flash and the LED Track Display (#20) will display "0" and blink. 2. Press the CD Skip Forward Button (#17) or CD Skip Backward Button (#16) to select the song to be programmed. 3. Press the Program Button (#21) again to store selection. The CD Program Indicator (#27) will flash and the LED Track Display (#20) will go to "0" and blink. 4.
AUTOMATIC STOP To protect your cassette tapes and prevent unnecessary wear to the pinch roller of the cassette mechanism, this unit is equipped with an Automatic Stop System. When the tape ends during play, the Cassette Play Button (#9) will automatically release to stop the cassette from running. CASSETTE TAPE OPERATING TIPS 1. 2. 3. 4. High quality tapes are recommended to obtain maximum quality reproduction from recordings.
CARE AND MAINTENANCE 1. 2. 3. 4. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used. Avoid leaving your unit in direct sunlight or in hot, humid or dust places. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. If drop-outs or interruptions occur in the music during CD play, or if the CD fails to play at all, its bottom surface may require cleaning.
TECHNICAL SPECIFICATIONS GENERAL Power Source ................................................. 240V 50Hz Power Consumption ....................................... 18W Dimensions (WxDxH) ..................................... 298 x 230 x 165 mm Weight ............................................................ 2.8 kgs RADIO Frequency Range .......................................... AM 522 - 1620kHz FM 87.5 - 108MHz CASSETTE SECTION Tape Speed .................................................... 4.
PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL: (02) 9313 7111 FAX: (02) 9313 7555 www.palsonic.com.