PW112SBF 112
Contents 1. SAFETY WARNINGS ............................................................................................................ 1 2. INSTALLTION ...................................................................................................................... 2 2.1 Location ...................................................................................................................... 2 2.2 Reversing the Door Swing ....................................................................
1. SAFETY WARNINGS Caution: risk of fire 1) WARNING―Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. 2) WARNING―Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. 3) WARNING―Do not damage the refrigerant circuit.
2. INSTALLTION 2.1 Location When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated with an average room temperature of between 16℃ and 38℃. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor installation.
3) Place to one side. 4) Slide the Appliance door down about 15cm and off the top hinge pin and lift away from the Appliance. 5) Remove the two screws from top bracket and replace on the otherside.You will need to first remove the plastic caps from the other side. 6) Slide the Appliance door back on to the Top hinge, making sure it’s the right way up. Screw the bottom hinge into place on the new side. Replace the other foot on the other side.
and dry completely before replacing in the unit. Clean the exterior of the unit with a damp cloth. If you require more information refer to the Cleaning section. 2.5 Before Using Your Unit Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is working properly and to allow it time to drop to the correct temperature. Your unit should not be overfilled. ◆ Before Plugging in You must check that you have a socket which is compatible with the plug supplied with the unit.
*All images in this instruction manual are for indication only; please refer to your individual unit for details. 4. OPERATION 4.1 Adjusting the Temperature OFF Users may adjust the refrigerator according to the actual needs. MIN MAX It is generally recommended to adjust to the third gear. Under the same ambient temperature, larger number stands for MED more robust refrigeration and lower temperature inside the chamber and vice versa.
Defrost the freezing compartment whenever the layer of frost on the surface of the evaporator reaches 3 or 4 mm. When defrosting remove all food and set the thermostat at “OFF” position. Put the drip tray under the evaporator to collect melted water. After the frost has melted, discard the melted water and dry up the interior of refrigerator. The refrigerator can then be restarted by turning its thermostat to the desired setting. 5.
department if the issues are not settled. Inoperation Odour Long-term operation of compressor Illuminating light does not shine The refrigerator door can not be properly closed. Loud noises Whether the freezer is plugged and connected to power; Low voltage; Failure power or tripping circuit Odorous foods should closely wrapped; Whether foods are rotten; Whether the interior shall be cleaned.
◆ The appliance should be located in the coolest area of the room, away from heat producing appliances or heating ducts, and out of the direct sunlight. ◆ Let hot foods cool to room temperature before placing in the appliance. Overloading the appliance forces the compressor to run longer. Foods that freeze too slowly may lose quality, or spoil. ◆ Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance. This cuts down on frost build-up inside the appliance.
Palsonic Customer Service Telephone (Australia) 1300 657 888 Palsonic Corporation Pty Ltd ABN 34 000 474 108 1 Joynton Avenue, Waterloo NSW 2017 Australia Telephone (02) 9313 7111 Facsimile (02) 9697 0655 www.palsonic.com.
