PW46SBF 46
Contents 1. SAFETY WARNINGS ............................................................................................................ 1 2. INSTALLTION ...................................................................................................................... 1 2.1 Location ...................................................................................................................... 2 2.2 Reversing the Door Swing ....................................................................
1. SAFETY WARNINGS 1) WARNING―Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. 2) WARNING―Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. 3) WARNING―Do not damage the refrigerant circuit. 4) WARNING―Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
2.1 Location When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor installation. Do not drape the unit with any covering.
4) Slide the Appliance door down about 15cm and off the top hinge pin and lift away from the Appliance. 5) Remove the two screws from top bracket and replace on the otherside.You will need to first remove the plastic caps from the other side. 6) Slide the Appliance door back on to the Top hinge, making sure it’s the right way up. Screw the bottom hinge into place on the new side. Replace the other foot on the other side.Replace the plastic covering by clicking back into position on the door hinge.
2.5 Cleaning Before Use Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water using a damp sponge or cloth. Wash the shelves and salad bin in warm soapy water and dry completely before replacing in the unit. Clean the exterior of the unit with a damp cloth. If you require more information refer to the Cleaning section. 2.
Small door Thermostat Drain tray Steel wire shelf Wire steel bar Adjustable foot *All images in this instruction manual are for indication only; please refer to your individual unit for details. 4. OPERATION 4.
refrigerant around the system. 4.3 Tips for Keeping Food in the Unit ◆ Cooked meats/fishes should always be stored on a shelf above raw meats/fishes to avoid bacterial transfer. Keep raw meats/fishes in a container which is large enough to collect juices and cover it properly. Place the container on the lowest shelf. ◆ Leave space around your food, to allow air to circulate inside the unit. Ensure all parts of the unit are kept cool.
6.3 Switching Of for Long Periods of Time When the unit is not in use for a long period of time, disconnect it from the mains supply, empty all food and clean the appliance, leaving the door ajar to prevent unpleasant smells. 7. Trouble shooting The following simple issues can be handled by the user. Please call the after-sale service department if the issues are not settled.
Before loading the appliance with packages of fresh food, make sure they are cooled to ambient temperature. Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3-5 mm thick. If it is the outer condenser, the rear wall should be always clean free of dust or any impurities. Always consider instructions stated in the ＂Positioning and Energy Saving Tips＂sections， otherwise the energy consumption might be substantially higher.
Palsonic Customer Service Telephone (Australia) 1300 657 888 Palsonic Corporation Pty Ltd ABN 34 000 474 108 1 Joynton Avenue, Waterloo NSW 2017 Australia Telephone (02) 9313 7111 Facsimile (02) 9697 0655 www.palsonic.com.
