Use and Care Manual

10
ASSEMBLY INSTRUCTIONS
Hardware Used
HH
II
JJ
8
9
8. Remove protective cover from reflector panel (A)
and reflector plate (B).
Note: In order to achieve proper alignment of
reflector sections, it may be necessary to loosen the
preassembled bolts prior to assembly and retighten
once complete.
9. Attach reflector panels (A) together using
M6 x 10 mm screws (II) and Φ6 washers (HH). Secure
loosely with cap nuts (JJ).
10. Attach reflector plate (B) to reflector panels (A)
using M6 x 10 mm screws (II) and Φ6 washers (HH).
Secure loosely with cap nuts (JJ). Once properly
aligned, tighten all screws and the preassembled bolts.
x 3
x 3
x 3
Φ 6 Washer
M6 X 10 mm Screw
B
JJ
HH
II
A
Cap Nut
Hardware Used
HH
II
JJ
x 6
x 6
x 6
Φ 6 Washer
M6 X 10 mm Screw
Cap Nut
10
JJ
HH
II