Use and Care Manual

7
ASSEMBLY INSTRUCTIONS
Hardware Used
AA
BB
Hardware Used
CC
1. Line up holes on the bracket of wheel assembly (O)
with the corresponding holes on base (M), then insert
M8 x 16 mm bolts (BB) through holes. Hand tighten with
M8 flange nuts (AA). Be sure the wheel assembly (O) is
parallel to the base (M).
2. Attach cylinder housing (H) loosely to base (M) with
M5 x 8 mm screws (CC).
x 2
M8 x 16 mm Bolts
M8 Flange Nut
x 2
M5 x 8 mm Screw
x 4
1
2
H
M
CC
M
AA
BB
O