Users Manual Part 2

Implementation Guide
Concepts
Pamex Enkore setup can be thought of in terms of three phases: Depending on the
progress of your project, there are three phases defined as :
● Construction Phase :
All the door locks are installed but not programmed yet. MF-Admin
server is not necessary for this phase.
● Lock Registration Phase :
The door locks are ready to be programmed/registered to the
MF-Admin server.
● Go-Live Phase :
All the locks are registered to MF-Admin Server. The system is ready
to go.
Normally, as time goes by, a project will first in the construction phase, then go to the
lock registration phase, then the go-live phase. Each phase requires different tasks to
be completed as described below.
In this guide, we will use the term Card or Key from time to time. Both terms refer to
the Mifare Card or Mifare key fob is issued by Pamex Enkore solution. Used by the
Pamex Enkore system.
MP100 is the only device you use to issue card/key. Note that sometimes you have to
re-place (take a card off the reader then place the card on the reader again) the card
on the reader to successfully complete your card operation. MF-Admin server will
remind you to re-place the card as possible as it can. But remember to do so when you
encounter MP100 reader error. It’s not a bug but the nature of Mifare Card operations.
7