Integration Manual

Integration Manual
Name Dept. date sheet of
Schreiber Simon R&D/HWR-MUL 27.09.2021 1 6
AUMA Riester GmbH & Co.
KG Tel [phone]
Aumastr.
1 Fax [phone]
79379 Müllheim, Germany [e-mail]
www.auma.com
Plastic Carrier
1 Introduction
The module with the associated PCB antenna is specially designed for various expansion stages of the
PROFOX electric actuator. The antenna in particular is adapted for the installation position in the housing. For
this reason, it is necessary to adhere to the installation specifications.
The following steps describe the integration of the module and the associated antenna.
2 Installation specifications
2.1 Integration steps
1. The module must be pushed completely into a plastic carrier for a fixed position (see Figure 1)
2. The Antenna Z135.074 must be pushed into the screw plug Z136.746 screwed into a metal housing
(see Figure 2)
3. After integrating the module Z123.664 and Z135.074, the 120 mm antenna cable must be connected
to the U.FL Connector on the module and the complete plastic carrier ist pushed in a metal housing
(see Figure 3)
4. The plastic carrier must be pushed down completely (see Figure 4)
5. The regulations were only checked with a completely closed metal housing. (see Figure 5)
Figure 1: Integration of the Module Z123.664 in a plastic carrier