Integration Guide

PAN9028 Bluetooth/Wi-Fi Module 1 About This Document
Module Integration Guide Rev. 1.0 Page 2 of 34
Overview
The PAN9028 is a 2.4 GHz/5 GHz ISM band Wi-Fi
and Bluetooth radio module, which includes a
wireless radio and a power management IC for
easy integration of Wi-Fi and Bluetooth connectivity
into various electronic devices.
Features
Dual band 2.4 GHz/5 GHz 802.11 a/b/g/n/ac
Wi-Fi and Bluetooth combo module
The hardware is capable of WPA3 and supports
802.11i security standards through AES and
CCMP
802.11e Quality of Service is supported for
multimedia application
IEEE 802.11ac (Wave 2), 1×1 spatial stream with
data rates up to 433 Mbps (MCS9, 80 MHz
channel bandwidth)
IEEE 802.11ac MU-MIMO beamformee
Bluetooth 5.2 (includes Low Energy)
Dual simultaneous and independent WLAN and
Bluetooth operation
Dynamic Rapid Channel Switching (DRCS) for
simultaneous operation in 2.4 GHz and 5 GHz
bands
Indoor location and navigation with
IEEE 802.11mc
Coexistence interface for arbitration of co-located
WLAN, Bluetooth, or mobile wireless system
(e.g. LTE or ZigBee
®
)
Generic interfaces include SDIO 3.0 and high
speed UART for host processor connection
Software driver Linux
®
Characteristics
Surface Mount Type (SMT):
24 mm × 12 mm × 2.8 mm
NXP
®
88W8987 WLAN 2.4 GHz/5 GHz and
Bluetooth single-chip solution inside
Single power supply: 3.3 V with NXP
PM823 Power Management IC (optional)
Tx power: 16 dBm at 802.11b
Rx sensitivity: -97 dBm at 802.11b DSSS 1 Mbps
IEEE 802.11ac 20 MHz, 40 MHz, 80 MHz
channel bandwidth
Long and Short Guard Interval support
Current consumption Wi-Fi typical 320 mA (at Tx)
and 70 mA (at Rx)
SDIO 1 bit or 4 bit
Wide temperature range of -30 °C to 85 °C
Block Diagram
Chip
Antenna
SPDT
NXP
â
88W8987
Radio SoC
UART
GPIOs
PDN
V
DD
+3.3 V
BPF
RF Pad
PAN9028
Wi-Fi and Bluetooth
â
Radio Module
IEEE 802.11 a/b/g/n/ac
Bluetooth 5.2 (BR, Low Energy, and EDR)
DPX
SPDT
PCM Interface
SDIO Interface
Sleep Clock
RF SW
Crystal
26 MHz
V
IO
/V
IOSD
COEX
PMIC
NXP
â
PM823
(optional)