Integration Guide


PAN9028 Wi-Fi/Bluetooth Module 10 Regulatory and Certi
Module Integration Guide Rev. 1.0 Page 29 of 45
It is recommended to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
10.1.3 Label Requirements
The OEM must ensure that FCC labelling requirements are met. This includes
a clearly visible label (laser marking) on the outside of the OEM enclosure
specifying the appropriate Panasonic FCC identifier for this product as well as
the FCC Notice above.
The FCC identifier for model ENWF9408A1EF is FCC ID: T7V9028.
The FCC identifier for model ENWF9408A2EF is FCC ID: T7V9028.
This FCC identifier is valid for the PAN9028. The end product must in any case
be labelled on the exterior with:
“Contains FCC ID: T7V9028”.
Due to the PAN9028 model size, the FCC identifier is displayed in the installation
instruction only and it cannot be displayed readable on the module’s label due to
the limited size.
10.1.4 Antenna Warning
This antenna warning refers to the test device with the model number ENWF9408A1EF and
ENWF9408A2EF in bottom pad mode (  Refer to PAN9028 Product Specification for RF-
Switch Pin Function).
The device is tested with a standard SMA connector and with the antenna listed below. When
integrated into the OEM’s product, these fixed antennas require installation preventing end
users from replacing them with non-approved antennas. Any antenna not in the following table
must be tested to comply with FCC Section 15.203 for unique antenna connectors and with
Section 15.247 for emissions. The FCC identifier for the device with the antenna listed in
10.1.5 Approved Antenna List is the same (FCC ID: T7V9028).