Schematics Part 1

DEKRA Certification, Inc.
405 Glenn Dr. Suite 12,
Sterling, VA 20164
United States of America
Report No: 2271ERM.007A1
Page 31 of 181
02-20-2019
TEST A.2: POWER LIMITS. MAXIMUM OUTPUT POWER
LIMITS:
Product standard:
Part 15 Subpart C §15.407 and RSS-247
Test standard:
Part 15 Subpart C §15.407(a) (1) (4) and RSS-247 6.2.1.1
LIMITS
In band 5.15-5.25 GHz, the maximum conducted output power over the frequency band of operation shall not
exceed 1 W provided the maximum antenna gain does not exceed 6 dBi. In addition, the maximum power spectral
density shall not exceed 17 dBm in any 1 megahertz band. If transmitting antennas of directional gain greater than
6 dBi are used, both the maximum conducted output power and the maximum power spectral density shall be
reduced by the amount in dB that the directional gain of the antenna exceeds 6 dBi.
TEST SETUP
Measured according to ANSI C63.10, Section 11.9.2.3.2 Method AVGPM-G
The EIRP power (dBm) is calculated by adding the declared maximum antenna gain to the measured conducted
power
TESTED SAMPLES:
S/01
TESTED CONDITIONS MODES:
TC#01 (a mode)
TEST RESULTS:
PASS
Bandwidth: 20 MHz
Maximum declared antenna gain: 0.7 dBi
Lowest frequency
5180 MHz
Middle frequency
5220 MHz
Highest frequency
5240 MHz
Maximum conducted power (dBm)
7.9
6.5
5.3
Maximum EIRP power (dBm)
8.6
7.2
6
Measurement uncertainty (dB)
<±0.78
The maximum directional gain of the antenna is less than 6 dBi and therefore the maximum output power is not
required to be reduced from the stated values.