User's Guide

Panasonic Avionics Corporation
26200 Enterprise Way, Lake Forest, CA 92630.
User’s Guide Requirements
The Bluetooth RJM module,
R8U4FJ5168Z complies with FCC Part 15 Rules for a
Modular Approval. The transmitter module must not be located close to any other
transmitter or antenna.
With the above condition, no other testing is required, but the manufacturer must still have
responsibility for the product compliance. In case the above conditions are not met, the FCC
authorization is no longer valid and FCC ID is not allowed to be used. For this reason,
manufacturer must have responsibility for the compliance of end product.
When manufacturer uses the
R8U4FJ5168Z module, it must include specific information
into user guide of the product. And manufacturer must not include information how to install
or remove this module in user guide. Manufacture must also put the following FCC
statements without any modification at prominent place in user guide.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on.
FCC Caution:
Any changes or modifications not expressly approved by Panasonic Avionics Corporation
could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
Industry Canada
Manufacturer shall place the following wording on the product and it shall be visible by the
customer at the time of purchase.
“Contains IC: 216P-BT850”