User's Manual

LR/WPAN PAN802154HAR Application Notes
Doc Number: Rev A3
15
Figure 7: Manually setting compile
3.6 Differences between the Panasonic PAN802154 and the Freescale SARD Development
Board
If the User is already familiar with the Freescale SARD Development Board – then using the PAN802154
is very easy.
The Panasonic PAN802154 has a different hardware configuration than the SARD board, improved RF
performance, one switch versus four; one LED versus four; the RS-232 interface has an additional
control connection to conserve power.
3.6.1 Switch
Setting the target settings to the SARD affects all the pin-outs for the PAN802154. The SARD board
layout includes four user switches labeled SW1, SW2, SW3, and SW4. However, the PAN802154 has
only one and it is labeled SW1. Nothing needs to be done in software due to this difference in layouts.
This should be kept in mind when attempting to run Freescale demonstration applications that uses
these switches.
The port used is the same for SW1 (PTD0).
3.6.2 LED
The SARD board had four LEDs as well, however, only one is used on the PAN802154. The port used
for the LED (LED1) is PTD0, which is the same as LED1 on the SARD board. This should be kept in
mind when developing software for the PAN802154s.