User's Manual
Table Of Contents
- Table of Contents
- 1 Camera Monitoring
- 1.1 Accessing the Camera
- 1.2 Viewing Live Camera Images
- 1.2.1 Using the Operation Bar
- 1.2.2 Aiming the Camera Lens
- 1.2.3 Limiting the Pan/Tilt Range
- 1.2.4 Registering and Changing Presets
- 1.2.5 Zooming
- 1.2.6 Backlight Correction
- 1.2.7 White Balance
- 1.2.8 Video Images and Image Refresh Rate
- 1.2.9 Taking Snapshots
- 1.2.10 Audio Features
- 1.2.11 Additional Features Available While Viewing Live Camera Images
- 1.3 Viewing Multiple Camera Images
- 1.4 Maximum Number of Viewing Sessions
- 1.5 Maximum Number of Viewing Sessions in Wireless Mode (BL-C230 Only)
- 2 Using Triggers to Buffer and Transfer Images
- 2.1 Configuring a Timer Trigger
- 2.2 Configuring a Sensor, Alarm, or Detection Trigger
- 2.3 Disabling and Enabling a Trigger
- 2.4 Configuring the Camera to Transfer Images
- 2.5 Configuring the Camera to Send Trigger Notifications
- 2.6 Viewing Buffered Images
- 2.7 Deleting Buffered Images Manually
- 2.8 Understanding How the Camera Manages Buffered Images
- 2.9 Adjusting Sensor Sensitivity
- 2.10 Adjusting Motion Detection Sensitivity
- 2.11 Adjusting Sound Detection Sensitivity
- 2.12 Sending Alarm Log Information
- 3 Mobile Phone Features
- 4 Configuring the Camera for Access from the Internet
- 5 Changing Camera Settings
- 6 User Accounts
- 7 Advanced Settings
- 8 Camera Administration and Maintenance
- 8.1 Confirming Camera Status
- 8.2 Confirming Wireless Status (BL-C230 Only)
- 8.3 Confirming Session Status
- 8.4 Confirming Alarm Logs
- 8.5 Restarting the Camera
- 8.6 Updating the Camera’s Firmware
- 8.7 Saving Settings in a Configuration File
- 8.8 Restoring Settings from a Configuration File
- 8.9 Resetting the Camera
- 9 The [Support] Tab
- 10 Using IPv6
- 11 PC Settings
- 12 Using the Setup Program
- 13 Technical Information
7. Enter the password
*2
provided by the Dynamic DNS service provider (max. 63 characters).
8. Click [Save].
*1
[Space] and ["] cannot be entered.
*2
["] and [:] cannot be entered.
Canceling the camera’s access to the Dynamic DNS service
Use the following procedure to stop the camera from notifying the Dynamic DNS service when your global IP
address changes. Note that if you intend to stop using the Dynamic DNS service altogether, you may need to
contact the Dynamic DNS service provider in order to cancel your subscription.
1. Click the [Setup] tab.
2. On the left side of the screen under [Basic], click [DynamicDNS].
3. Select [Disable], then click [Save].
110 Operating Instructions
4.2.2 Configuring the Camera to Use a Third-party Dynamic DNS Service