2.4GHz Cordless Answering System Model No. KX-TG2584S Pulse-or-tone dialing capability Operating Instructions Contents: Location of Controls Connections Battery Installation/Battery Charge Recording a Greeting Message Making/Answering Calls with the Handset Making/Answering Calls with the Portable Handset Caller ID Service Automatic Answering Operation Listening to Messages Important Safety Instructions FCC and Other Information PLEASE READ BEFORE USE AND SAVE.
Please read IMPORTANT SAFETY INSTRUCTIONS on pages 11 before use. Read and understand all instructions.
∫Base unit (ANSWER\ON) Button (MESSAGE\PLAYBACK) Button Antenna Antenna One-Touch Auto Dial Buttons (TONE) Button (REPLAY\PAUSE) Button (HOLD) Button (FLASH/CALL\WAIT) Button –3–
∫Base unit (FUNCTION/EDIT) Button (CLEAR/ERASE) Button Display (STOP/EXIT) Button Navigator Key ((‹), (›), (fi), (fl)) (CONFERENCE) Button (RINGER) Button (LOCATION/INTERCOM) Button (MUTE) Button (DIGITAL\SP-PHONE) Button and indicator MIC (Microphone) –4–
Connections ∫Connect the AC adaptor and the telephone line cord. Single-Line Telephone Jack (RJ11C) Telephone Line Cord Power Outlet (AC 120 V, 60 Hz) Raise the antennas. AC Adaptor Fasten the AC adaptor cord to prevent it from being disconnected. Hook ≥USE ONLY WITH Panasonic AC ADAPTOR PQLV10ZA. ≥The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.
Battery Installation/Battery Charge ∫Battery installation 1 Install the battery in the handset. 2 Close the handset cover. ∫Battery Charge To power the handset, charge the battery. Place the handset on the charger for about 15 hours before initial use. ∫Recharge Recharge the battery when: —“Recharge battery” is displayed, —“ ” flashes on the display, or —the handset beeps intermittently while it is in use. ≥Clean the charge contacts of the handset and the charger with a soft, dry cloth once a month.
Recording a Greeting Message You can record a personal greeting message of up to 2 minutes. If a greeting message is not recorded, one of two pre-recorded greetings will be played when a call is received. ≥All messages (greeting, incoming, etc.) are stored in digital memory. The total recording time is about 15 minutes. We recommend you record a brief greeting message in order to leave more time for recording new messages. 1 Press (FUNCTION). 2 Press (‹) or (›) until the arrow points to “Greeting record”.
Making/Answering Calls with the Handset ∫To make a call 1 Lift the handset or press (DIGITAL\SP-PHONE). 2 Dial a telephone number. 3 To hang up, place the handset on the cradle or press (DIGITAL\SP-PHONE). ≥To redial the last number, lift the handset or press (DIGITAL\SP-PHONE), then press (REDIAL/PAUSE). ≥To adjust the receiver volume/speaker volume: To increase, press (‹). To decrease, press (›). ≥To put a call on hold, press (HOLD). ≥To release the hold, press (HOLD).
Making/Answering Calls with the Portable Handset ∫To make a call 1 Press . 2 Dial a telephone number. 3 To hang up, press . ≥To redial the last number, Press , then press (REDIAL/PAUSE). ≥To adjust the speaker volume: To increase, press (‹). To decrease, press (›). ≥To put a call on hold, press (INTERCOM/HOLD). ≥To release the hold, press . ∫To answer a call Press . Caller ID Service This unit is compatible with a Caller ID service offered by your telephone company.
Automatic Answering Operation ∫Setting the unit to answer calls Press (ANSWER\ON) to turn on the answering system. ≥The indicator lights and “Answer set” is heard. Listening to Messages You can see the total number of recorded messages on the base unit display. To listen to the messages, press (MESSAGE\PLAYBACK). ≥When you have new messages, the unit announces the number of new messages and plays them back. ≥When you have no messages, the unit plays back all recorded messages.
Important Safety Instructions When using this unit, basic safety precautions should always be followed to reduce the risk of fire, electric shock, or personal injury. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on this unit. 3. Unplug this unit from AC outlets before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use this unit near water, for example, near a bathtub, washbowl, kitchen sink, or the like. 5.
CAUTION: To reduce the risk of fire or injury to persons, read and follow these instructions. 1. Use only the battery(ies) specified. 2. Do not dispose of the battery(ies) in a fire. They may explode. Check with local waste management codes for special disposal instructions. 3. Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed. 4.
FCC and Other Information If requested by the telephone company, inform them as follows: Registration No. . . . . . . . . . . . . . . . . . . . . . . .(found on the bottom of the unit) Ringer Equivalence . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0.1B The particular telephone line to which the equipment is connected. This unit must not be connected to a coin operated line. If you are on a party line, check with your local telephone company. Ringer Equivalence No.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
≥Environment—do not place the unit in a room where the temperature is less than 5oC (41oF) or greater than 40oC (104oF). Allow 10 cm (4q) clearance around the unit for proper ventilation. Avoid excessive smoke, dust, mechanical vibration, shock, or direct sunlight. ≥Medical—consult the manufacturer of any personal medical devices, such as pacemakers, to determine if they are adequately shielded from external RF (radio frequency) energy.
For product service ≥Call 1-800-211-PANA(7262) for the location of an authorized servicenter. ≥Panasonic’s e-mail address for customerinquires: consumerproducts@panasonic.com for customers in the USA or Puerto Rico ONLY When you ship the product ≥Carefully pack your unit, preferably in the original carton. ≥Attach a letter, detailing the symptom, to the outside of the carton. Symptom ≥Send the unit to an authorized servicenter, prepaid and adequately insured.