User's Manual

13
Getting Started
7 Setup Windows.
Moving the cursor ( ) or clicking buttons can be performed with the touch pad.
The touchscreen does not work properly during the Windows setup.
<Only for models with XGA type LCD>
During the Windows setup procedure, the desktop will be displayed as a small
screen in the center of the LCD. After the setup procedure is completed and the
computer is restarted, the desktop will be displayed as a full screen.
NOTE
Select settings for your region, then select [Next].
4 Enter your name and organization and then select [Next].
5 Enter your computer name and administrator password and then select [Next].
Do not press any keys or touch the touch pad until [Windows XP Professional
Setup] is displayed.
CAUTION
Windows XP
1 At [Welcome to the Windows XP Setup Wizard], select [Next].
2 After reading the agreement, select [I accept this agreement] or [I don’t accept this
agreement], then select [Next].
NOTE
If [I don’t accept this agreement] is selected, the Windows setup will be aborted.
3
CAUTION
Remember this password! If the password is forgotten, Windows cannot be
operated.
7 At [Networking Settings], select [Typical settings], then select [Next].
8 At [Workgroup or Computer Domain], select [No, this computer is not on a network,
or is on a network without a domain], then select [Next].
The computer will restart.
NOTE
It may take two to three minutes until the next screen is displayed. Wait, and
do not press any keys, or touch the touch pad, etc.
If “Yes, make this computer a member of the following domain” is selected,
the following message may be displayed: [An invalid domain was specified.
Would you like to proceed for now and try joining a domain later?]. In this
case, select [Yes]. After selecting [Yes], the computer will restart automati-
cally, but sometimes the message [Windows is starting up] will remain on the
screen, and windows will not start up. If this happens, hold Tab down while
pressing Alt until [Network Identification Wizard] is displayed on top, and
follow the instructions on the screen.
NOTE
6 Enter the correct date, time and time zone, then select [Next].
9 Enter your administrator password and select .
Wait until the hard disk drive indicator ( ) has turned off.