User's Manual

ManualsBrandsPanasonic Corporation of North America ManualsComputers & AccessoriesPanasonic Notebook PC w/ Intel WLAN

Operation

1 Open the display.

Starting Up/Shutting Down

Starting Up

2 Turn your computer on.

Slide the power switch and hold it for approximately one second until the power indicator

turns on before releasing it.

Under the condition that both the AC adaptor and the port replicator are not con-

nected, the power will not go on if the display is closed.

While booting, avoid the following until the hard disk drive indicator ( ) has

turned off.

• Connecting or disconnecting the AC adaptor.

• Touching the power switch.

• Performing any keyboard, touch pad, touchscreen (only for models with touch-

screen), or external mouse operations.

• Closing the display.

Once the computer is powered off, you must wait at least ten seconds before pow-

ering it on again.

When the CPU temperature rises, the computer may not power on to prevent the

CPU from overheating. Should this happen, allow the computer to cool down then

switch the power on again.

If the computer still does not power on, contact Panasonic Technical Support.

CAUTION

1 Pull the carrying handle forward.

2 Press the latch as illustrated.

3 Lift up the latch and open the display.

Three incorrect attempts

No password for about a minute

The correct password

Will Start

Enter your password*

and press Enter . ( “Security Measures”)

Will Not Start

(Power off)

If [Enter Password] is displayed

Supervisor Password or User Password set in the Setup Utility (not

the Windows password).

Enter Password [ ]

When the power is turned on, sometimes the message “Warming up the system” is

displayed or the battery indicator alternately blinks green and orange, and start-up

takes longer than usual (a few minutes or more). This function is designed to

prevent hard disk drive malfunctions that may occur at low temperatures. Please

wait for the computer to start up.

NOTE

Power Indicator

Power Switch

When an application or file that was previously displayed

appears on your screen

The standby or hibernation mode has been set ( “Standby/Hibernation Func-

tions”).

Latch