User's Manual

Operation

3 Log on to Windows

Windows 2000

After confirming that the hard disk drive indicator ( ) has turned off, input the user

name and password, then select [OK]. Until the correct user name and password are

entered, the computer will not operate.

Windows XP

After confirming that the hard disk drive indicator ( ) has turned off, select the user

and input the password, then select . Until the correct password is entered, the

computer will not operate.

4 Select your application

You are able to start working on your computer.

The power saving function is factory set, so if there is no input from a key, the touch

pad, the touchscreen (only for models with touchscreen) or an external mouse (when

one is connected) for a certain interval of time, the power to the LCD and hard disk

may be turned off. The LCD will resume operation when the touch pad, the

touchscreen (only for models with touchscreen) or an external mouse (when one is

connected) is used or a key is pressed.

The power to the LCD may be turned off even when an application software is being

installed. In this case, because it is conceivable that a selection dialog box will be

shown, do not press Space or Enter to attempt to resume from this condition

as doing so may trigger a selection, but instead, press a key unrelated to the direct

triggering of a selection, like Ctrl .

In addition, when the computer is left alone, it automatically enters the standby or

hibernation mode ( “Standby/Hibernation Functions”). The computer will

resume by pressing the power switch.

Windows XP

When switching to a different user with the Fast User Switching function, it may not

be possible to set the settings of the display. In this case, log on with the administra-

tor authority again, not using the Fast User Switching function, and try the operation

once more.

NOTE

Three incorrect attempts

No password for about a minute

The correct password

Will Start

Will Not Start

(Power off)

If [Enter Password] is displayed

Enter your password* and press Enter . ( “Security Measures”)

* Supervisor Password or User Password set in the Setup Utility (not

the Windows password).

When an application or file that was previously displayed

appears on your screen

The standby or hibernation mode has been set ( “Standby/Hibernation

Functions”).

Enter Password [ ]