User Manual

ManualsBrandsPanasonic Corporation of North America ManualsComputers & AccessoriesNotebook Computer with Wireless LAN

Getting Started

Windows NT

1 The License Agreement will be displayed. After reading the agreement, select [I

accept this Agreement].

2 Select [Next].

3 Input your name and organization, then select [Next]. (It is possible to omit the

organization item.)

4 Input your computer name and select [Next].

5 Input an Administrator password and select [Next].

6 Select [Finish]. Windows will restart.

7 Following the display, press Ctrl + Alt + Del . Input the password set in

step 5 and select [OK], then select [Close] at the [Welcome] display.

As the computer starts up, it will be necessary to input the password set in step

8 Set the correct settings for all items in [Control Panel]-[Regional Settings] and

[Date/Time] etc.

If [I don’t accept this Agreement] is selected, the Windows setup will be

aborted.

NOTE

CAUTION

Remember this password! If the password is forgotten, Windows NT cannot

be operated.

1 At the [Welcome to the Windows 2000 Setup Wizard], select [Next].

2 After reading the agreement, select [I accept this agreement] or [I don't accept

this agreement], then select [Next].

Windows 2000

Do not press any key or move the touch pad until [Windows 2000 Profes-

sional Setup] is displayed.

CAUTION

First-time Operation

NOTE

If [I don’t accept this agreement] is selected, the Windows setup will be

aborted.

CAUTION

3 Select settings for your region, then select [Next].

4 Enter your name and organization and select [Next].

5 Enter your computer name and administrator password and select [Next].

Remember this password! If the password is forgotten, Windows 2000 can-

not be operated.

NOTE

At the [Getting started with Windows 2000], select [Exit] to close.

6 Input the correct date, time and time zone and select [Next].

You can also complete these settings at a later time.

7 At the [Networking Settings], select [Typical settings], then select [Next].

8 At the [Workgroup or Computer Domain], select [No, this computer is not on a

network, or is on a network without a domain], then select [Next].

The computer will restart.

9 At the [Network Identification Wizard], select [Next].

At the [Users of This Computer], select [Users must enter a user name and pass-

word to use this computer], then select [Next].

Select [Finish].

Enter your administrator password and select [OK].