DBUB-PSG(81DBUB13.G41) Bluetooth Module User’s Manual This document provides safety instructions and describes the specifications. Read this document carefully before installing to ensure your safety and product performance.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID:內 ACJ-B30R1301”. The grantee's FCC ID can be used only when all FCC compliance requirements are met.
Industry Canada statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence.
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the Canada authorization is no longer considered valid and the IC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate Canada authorization.
For Taiwan： Taiwan： 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更 頻率、加大功率或變更原設計之特性及功能。 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應 立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之 無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機 設備之干擾。 Note: 1. 本模組於取得認證後將依規定於模組本體標示審驗合格標籤 2. 平台上標示「本 品 含射頻模組: 系統廠商應於 XXXyyyLPDzzzz-x」字樣 內 Caution: Be aware of the following limits before using the Bluetooth Module. Do not subject the Bluetooth Module to high temperatures, direct sunlight or moisture.
Specification Specifications Power supply DC 3.3V 38.5mA(typical) Antenna Tx 1, Rx 1 Host Interface USB 2.0 + GPIO x1 Standard Compliance Bluetooth 3.0 Frequency Range 2.4 GHz (2.40GHz-2.4835GHz) ・GFSK Modulation ・Pi/4 QPSK ・8DPSK Receiver Sensitivity Transfer rate (standard) * Output Power Security -88 dBm(typ.) GFSK, 0.1%BER -85 dBm(typ.) for pi/4-DQPSK, 0.01%BER 3.0Mbps(MAX, Theoretical Value) Class 2, 0dBm typical, class 2 device (-6dBm < output power <4dBm).
