Instruction Manual
8
CHAPTER 4 GUIDE TO OPERATION
4.1 INSTALLATIONS
• Starting the drive.
➀ Turn on the power supply.
➁ Press the eject button. The tray is ejected from the drive.
➂ Place the disc in the tray with the disc's label facing up.
➃ Press the eject button or press the tray lightly as in the following figure.
The tray is retracted automatically.
➄ Loading start.
CAUTION:
• Do not insert any foreign objects into the disc tray. This could result in a
malfunction.
• Do not manually force the tray to open.
• When the drive is not in use, keep the tray closed to protect against dust and
dirt.
• Do not press down hard on the tray when loading a disc, since this may result
in damage to or malfunction of the tray.
• In case of emergency, eject the tray manually
If for some reason the tray will not eject automatically, press
the eject-bar (for example, insert a straightened
paper clip minimum straight length = 45mm, Diameter = 1~
1.5mm) into the emergency eject hole to manually eject the
tray. (Before proceeding with this emergency step, make sure
that the power is switched OFF.)
Min. 45 mm
Paper clip