User Manual

CLASSIFICATION
PRODUCT SPECIFICATION
No.
DS-9320-2400-102
REV.
1.1
SUBJECT
WI-FI IEEE 802.11 BGN FULL EMBEDDED MODULE
PAGE
35 of 43
CUSTOMER’S CODE
PAN9320 / PAN9310
PANASONIC’S CODE
ENW49A01x3EF & ENW49A02x3EF
DATE
14.03.2016
PANASONIC INDUSTRIAL DEVICES EUROPE GMBH
www.pideu.panasonic.de
26.5. SAFETY CAUTIONS
These specifications are intended to preserve the quality assurance of products and individual
components.
Before use, check and evaluate the operation when mounted on your products. Abide by these
specifications, without deviation when using the products. These products may short-circuit. If electrical
shocks, smoke, fire, and/or accidents involving human life are anticipated when a short circuit occurs,
then provide the following failsafe functions, as a minimum.
(1) Ensure the safety of the whole system by installing a protection circuit and a protection
device.
(2) Ensure the safety of the whole system by installing a redundant circuit or another system to
prevent a single fault causing an unsafe status.
26.6. OTHER CAUTIONS
(1) This specification sheet is copyrighted. Do not disclose it to a third party.
(2) Do not use the products for other purposes than those listed.
(3) Be sure to provide an appropriate fail-safe function on your product to prevent an additional
damage that may be caused by the abnormal function or the failure of the product.
(4) This product has been manufactured without any ozone chemical controlled under the
Montreal Protocol.
(5) These products are not intended for other uses, other than under the special conditions
shown below. Before using these products under such special conditions, check their
performance and reliability under the said special conditions carefully to determine whether
or not they can be used in such a manner.
 In liquid, such as water, salt water, oil, alkali, or organic solvent, or in places where liquid
may splash.
 In direct sunlight, outdoors, or in a dusty environment
 In an environment where condensation occurs.
 In an environment with a high concentration of harmful gas (e.g. salty air, HCl, Cl2, SO2,
H2S, NH3, and NOX)
(6) If an abnormal voltage is applied due to a problem occurring in other components or
circuits, replace these products with new products because they may not be able to provide
normal performance even if their electronic characteristics and appearances appear
satisfactory.
(7) When you have any question or uncertainty, contact Panasonic.