User Manual

CLASSIFICATION
PRODUCT SPECIFICATION
No.
DS-9320-2400-102
REV.
1.1
SUBJECT
WI-FI IEEE 802.11 BGN FULL EMBEDDED MODULE
PAGE
41 of 43
CUSTOMER’S CODE
PAN9320 / PAN9310
PANASONIC’S CODE
ENW49A01x3EF & ENW49A02x3EF
DATE
14.03.2016
PANASONIC INDUSTRIAL DEVICES EUROPE GMBH
www.pideu.panasonic.de
31.1.5. Approved Antenna List
Note: We are able to qualify your antenna and will add to this list as that process is completed.
31.1.6. RF Exposure
To comply with FCC RF Exposure requirements, the Original Equipment Manufacturer (OEM) must
ensure that the approved antenna in the previous table must be installed.
The preceding statement must be included as a CAUTION statement in manuals for products
operating with the approved antennas in the previous table to alert users on FCC RF Exposure
compliance.
Any notification to the end user of installation or removal instructions about the integrated radio
module is not allowed.
The RF exposure requirements of PAN9320 with mounted ceramic chip antenna (FCC ID: T7V-
9320 for model ENW49A01A3EF) are fulfilled for mobile configuration. The installation of the
module is restricted to mobile host devices. Nevertheless, the PAN9320 shall be used in such a
manner that the potential for human contact during normal operation is minimized.
End users may not be provided with the module installation instructions. OEM integrators and end
users must be provided with transmitter operating conditions for satisfying RF exposure compliance.
31.2. INDUSTRY CANADA CERTIFICATION
PAN9320 and versions are licensed to meet the regulatory requirements of Industry Canada (IC),
License for M/N: ENW49A01x3EF
(16)
: IC: 216Q-9320
License for M/N: ENW49A02x3EF
(16)
: IC: 216Q-9320
Manufacturers of mobile, fixed or portable devices incorporating this module are advised to clarify
any regulatory questions and ensure compliance for SAR and/or RF exposure limits. Users can
obtain Canadian information on RF exposure and compliance from www.ic.gc.ca.
This device has been designed to operate with the antennas listed in 31.1.5 above, having a
maximum gain of +0.8dBi. Antennas not included in this list or having a gain greater than +0.8dBi
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. The
antenna used for this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Due to the model size the IC identifier is displayed in the installation instruction only and can’t be
displayed on the modules label due to the limited size.
31.2.1. IC Notice
The device PAN9320 and versions, for details refer to Chapter 28. Ordering Information, including
the antennas, which are listed in 31.1.5, complies with Canada RSS-GEN Rules. The device meets
the requirements for modular transmitter approval as detailed in RSS-GEN.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Item
Part Number
Manufacturer
Frequency Band
Type
Gain (dBi)
1
ANT2012LL13R2400A
Yageo
2.4GHz
Chip-Antenna
+0.8