User Manual

CLASSIFICATION PRODUCT SPECIFICATION
No.
DS-1026-2400-102
REV.
0.3
SUBJECT
CLASS 2 BLUETOOTH LOW ENERGY
SPP MODULE
PAGE 20 of 35
CUSTOMER’S CODE
PAN1026
PANASONIC’S CODE
ENW89837AxKF
DATE 02.10.2013
PANASONIC INDUSTRIAL DEVICES EUROPE GMBH www.pideu.panasonic.de
17 RELIABILITY TESTS
The measurement should be done after being exposed to room temperature and humidity for 1
hour.
No. Item Limit
Condition
1 Vibration test
Electrical parameter should be in
specification
a) Freq.:10~50Hz,Amplitude:1.5mm
a) 20min. / cycle,1hrs. each of XYZ axis
b) Freq.:30~100Hz, 6G
b) 20min. / cycle,1hrs. each of XYZ axis
2 Shock test the same as above Dropped onto hard wood from height of 50cm for 3 times
3 Heat cycle test the same as above
-40°C for 30min. and +85°C for 30min.;
each temperature 300 cycles
4 Moisture test the same as above +60°C, 90% RH, 300h
5 Low temp. test the same as above -40°C, 300h
6 High temp. test the same as above +85°C, 300h
18 CAUTIONS
Failure to follow the guid
elines set forth in this document may result in degrading of the product’s
functions and damage to the product.
18.1 DESIGN NOTES
(1)
Follow the conditions written in this specification, especially the control signals of
this module.
(2) The supply voltage has to be free of AC ripple voltage (for example from a
battery or a low noise regulator output). For noisy supply voltages, provide a
decoupling circuit (for example a ferrite in series connection and a bypass
capacitor to ground of at least 47uF directly at the module).
(3) This product should not be mechanically stressed when installed.
(4) Keep this product away from heat. Heat is the major cause of decreasing the life
of these products.
(5) Avoid assembly and use of the target equipment in conditions where the
products' temperature may exceed the maximum tolerance.
(6) The supply voltage should not be exceedingly high or reversed. It should not
carry noise and/or spikes.
(7) Keep this product away from other high frequency circuits.