User's Manual

15
Introduction
Where it is used Material/Finishing
Label (Battery compartment) Polyester
Inner cover inside the back cover PC, Silicon rubber
1Seg
antenna
Tip resin part ABS/UV coating
Metal part
(Bottom of the tip resin
part)
Stainless steel
Metal part (Wire area) Nickel
-
titanium alloy
Hinge area at bottom
part
Stainless steel
Holder area Zinc alloy/nickel plating
⿠Different materials may be used in some areas depending on the
body color
.
※1 Body color “White” “Pink”
※2 Body color “Pink Gold”
Handling Precautions
General notes
The P-06C is provided with the waterproof performance,
however, do not have water entered into the inside of the
FOMA terminal, or do not spray water over accessories and
optional items.
The battery, adapter, desktop holder, and UIM are not
waterproofed. Do not use them in environments, which are high
in humidity such as in bathrooms, and do not allow them to get
wet from rain. Furthermore, if
carrying them against your body,
they become moist due to perspiration and the internal parts may
become corroded, causing malfunction.
If the parts are found to have been damaged due to exposure to
the liquids, any repairs will not be covered by warranty, or repairs
may not be possible.
This may be repaired at a cost if repairs are possible.
Use a dry soft cloth such as the one for cleaning glasses to
c
lean the equipment.
⿠
The display may be scratched if it is rubbed hard with a dry cloth.
⿠Stains may result from droplets of water or dirt if they are left
on the display.
⿠Do not use alcohol, thinner, benzene, detergent or other
solvents for cleaning, otherwise the printing may be removed
or discoloration may result.
Occasionally clean the terminals of the equipment using a
dry
cotton swab, etc.
The soiled terminals deteriorate the connection and might cause
power discontinuity or incomplete charging. Wipe the terminals
with a cotton swab, etc.
Take care not to damage the terminals when cleaning them.
Do not place the FOMA terminal near an air conditioner outlets.
Condensation may form due to rapid changes in temperature,
and this may corrode internal parts and cause malfunction.