User's Manual

12
Introduction
List of materials used
■P-01E Handset/Back Cover P58/Battery
Pack
P23
Where it is used Material/Finishing
Outer
casing
Display
surface,
Batter
y
surface,
Batter
y
surface
(Hinge
side
)
PC
/UV coating
Connector
terminal Stainless steel/
nickel plating + tin
plating
Connector
terminal
cover
Body PC/UV coating
Fitting pin
area
Elastomer
Packing Silicon rubber
Panel of
camera lens
area, Display
panel,
Sub
-
display panel
PMMA
/hard coating
Side key ABS
Around
the side key ABS/UV coating
Charging
terminal Brass/nickel plating
+ nickel palladium
plating + gold
plating
Key
area, Sheet area of
numeric key surface
Acrylic urethane
Batter
y compartment
surface
Stainless steel/
nickel plating
Where it is used Material/Finishing
Batter
y
terminal
Resin part PA
Terminal
area
Titanium copper
/
nickel plating + gold
plating
Batter
y
pack
Resin part PC
Label PET
Terminal
area
Glass epoxy
substrate/nickel
plating + gold
plating
docomo
mini UIM
card
tray
Resin part LCP
Metal part Stainless steel/
nickel plating + gold
plating
Hinge area Center
area of
display
surface,
Hinge
support
area, Both
ends area
PC/UV
coating
Center
area of
sub
-
display
surface
ABS
/UV coating
Label (Batter
y
compartment
)
PET
Back
cover Body PC/UV coating
Packing Silicon rubber
One
-
push open button PC
■Desktop Holder P51
Where it is used Material/Finishing
Outer
casing ABS
Connector
terminal PPS
Cushion Urethane
Charging terminal Phosphor bronze/
nickel plating + gold
plating
Label PS
Lever POM
Handling Precautions
General notes
■The P-01E is provided with the
waterproof/dust
-
proof
performance,
however, do not allow water
to seep or
dust
to get in the inside of the FOMA
terminal, or
do not allow accessories and
optional items
to get wet or adhere dust.
The battery, adapter, desktop holder,
and docomo mini UIM card are not
waterproofed/dust
-
proofed. Do not use
them in environments, which are high
in humidity
such as in bathrooms, and
do not allow
them to get wet from rain.
Furthermore, if
carrying them against
your
body, they become moist due to
perspiration and
the internal parts may
become corroded, causing malfunction.
If
the parts are found to have been
damaged due
to exposure to the liquids,
any
repairs will not be covered by
warranty, or
repairs may not be possible.
This may
be repaired at a cost if repairs
are possible.