User's Manual

19
Basic Operation
Before Using
Attaching docomo mini UIM card/
Batt
ery Pack
To insert the docomo mini UIM card/battery pack, remove
the back cover and insert. (See page 16)
1
Insert the docomo mini
UIM card
.
1.
Pulling the tab of the tray with your
finger,
slowly pull the tray straight
out until it stops.
⿠The tray
cannot be removed, so be
sure not to pull the tray beyond the
position at which
it stops. Doing so
might damage the tray
or tab.
2.
With the gold IC side of the
docomo mini UIM card
facing up,
check that the cut is facing left, and
place the card
in the tray.
3.
Push the docomo mini UIM card
until it stops.
⿠Pu
sh the docomo mini UIM card
inwa
rd firmly until it is in place.
When you remove the docomo mini UIM card
Pu
ll out the tray, and then slide the docomo mini UIM card
slowly to pull it out.
⿠After pulling out the tray
until about half of the docomo
mini UIM card
is visible, pull out the docomo mini UIM
card by sliding it out.
2
Attach the battery
pack
.
With the arrow mark on the
battery pack facing up, insert
the side of the battery pack
that is in the dire
ction of
the arrow
inside the FOMA
terminal, and then push in
the A dire
ction while pushing down in the B direction.
When you re
move the battery pack
Lift the battery up using the projection of it.
⿠Ensure that you turn off, close, and take hold of the FOMA
term
inal when you install or remove the docomo mini UIM
card or battery pack.
⿠Yo
u can use only a docomo mini UIM card with this FOMA
terminal. If you have a docomo UIM card or FOMA card,
re
place it at a handling counter of a docomo Shop.
Tab
Cut
Arrow mark
Projection