User's Manual Part 1
59
Voice/Videophone Calls
You can store prefix numbers such as international call
access codes or “186”/“184” and add them to the
phone number for dialing. You can store up to seven
prefix numbers.
1
m
Settings
Network setting
Prefix setting
Highlight <Not recorded>
and press
l
().
p
If you select a stored prefix, you can check the stored
contents.
p
To delete a stored prefix, press
i
( ) and select
“Delete this” or “Delete all” then select “YES”. If you select
“Delete all”, you need to enter your Terminal Security Code.
2
Enter a name
Enter a prefix number.
p
You can enter a name of up to 8 full-pitch/16 half-pitch
characters.
p
You can enter a prefix number of up to 16 digits. The
keys for entry are limited to
0
through
9
,
s
and
a
.
You can add a prefix number to the beginning of phone
number when you make a call.
1
Enter a phone number
or
bring up the detailed display of a
Phonebook entry, redial item, dialed call
record, or received call record.
Function Menu while Country Code Setting/IDD
Prefix Setting is Displayed
Function menu
Operation/Explanation
Edit
Go to step 2 of “Country Code Setting” on
page 58 for Country Code Setting, and go to
step 2 of “IDD Prefix Setting” on page 58 for
IDD Prefix Setting.
p
You can edit the item also by pressing
l
().
Delete this
YES
Delete all
Enter your Terminal Security Code
YES
Information
<
Delete this
> <
Delete all>
p
You cannot delete the country code or international call
access code set by “Auto assist setting”.
Prefix Setting
Storing Numbers to be Added to
the Beginning of a Phone Number
<>
Prefix Numbers
2
i
()
Prefix numbers
Select a name
d
or
Oo
()
p
Press
l
( ) to make a videophone call and
press
p
to make a PushTalk call.
p
For making a PushTalk call, adding a prefix number
such as “186” or “184” to the beginning of the phone
number is disabled.
You can set whether to regard the numbers after “
:
” of
a phone number as a sub-address to access the
specified phones or data terminals.
p
The sub-address is a number assigned to identify each ISDN
terminal connected to an ISDN line. It is also used for
selecting contents on “V-live”.
1
m
Settings
Other settings
Sub-address setting
ON or OFF
You can set an alarm that sounds until a voice call,
videophone call, or PushTalk communication is
reconnected after disconnected owing to bad radio
wave conditions.
1
m
Settings
Talk
Reconnect signal
Select an alarm.
1
m
Settings
Talk
Noise reduction
ON or OFF
Sub-address Setting
Making a Call with Specified
Sub-address
<>
Information
p
Even if you set “Sub-address setting” to “ON”, “
:
” at the top
of phone numbers and “
:
” immediately after the prefix
number or “186”/“184” are not regarded as sub-address
mark-off symbols.
+m-7-7
Reconnect Signal
Setting Alarm for Reconnecting
<>
Information
p
The reconnectable time differs depending on the usage
status and radio wave conditions. An estimate is about 10
seconds and the call charge is applied also for that duration.
p
While you are disconnected, no sound is transmitted to the
other party.
+m-7-6
Noise Reduction
Reducing Surrounding Noise to
Make Voice Clear
<>