User's Manual Part 1

64
Voice/Videophone Calls
You can adjust the ring volume for incoming calls and mail.
1
m Settings  Sound  Ring volume
 Select an incoming type
 Use Bo to adjust the volume.
p Following icons are displayed on the Stand-by display
while the ring volume is set to “Silent”:
: The ring volume for voice calls, PushTalk calls or
videophone calls is “Silent”.
: The ring volume for mail, chat mail or Messages
R/F is “Silent”.
: The ring volume for voice calls, PushTalk calls, or
videophone calls is “Silent” and the ring volume
for mail, chat mail, or Messages R/F is “Silent”.
p If you have set “Step”, the ring tone is silent for about
three seconds, and then the volume steps up every
three seconds, from Level 1 through Level 6.
p During ringing of a voice call or videophone call, you
can adjust the ring volume also by pressing
Bo or by
pressing and holding
< / > for at least one second.
However, you cannot adjust the ring volume in the
following cases:
・ Ring Volume is set to “Step”.
・ “Answer setting” is set to “Quick silent” and you stop
the ring tone or voice guidance.
・ During Manner Mode
・ Incoming calls within the ring start time specified by
“Ring time”
1
During ringing h
The FOMA phone makes three rapid beeps for
confirmation and the call is put on answer-hold (On Hold).
p The confirmation tone does not sound while Manner Mode
is activated or when “Phone” of “Ring volume” is “Silent”.
p The other party hears the hold tone set for “On hold
tone” of “Set hold tone”. For videophone calls, the still
image set for “On hold” of “Select image” is displayed.
2
Press Oo () or d to release hold
and answer the call.
p If “Answer setting” is set to “Any key answer”, you can
release hold of voice calls by pressing any key of
0
through 9 , a , s , r , m , c , Mo ,
< , > , l , or i .
p If a videophone call is on hold, the image through your
camera is sent to the other party by pressing
Oo () or d to release hold. If you press
m ( ) to release hold, the substitute image is sent.
+m-5-0
Ring Volume
Adjusting Ring Volume
<>
On Hold
Putting an Incoming Call on Hold
when You cannot Answer at Once
<>
1
During a call Oo ()
p The other party hears the hold tone set for “Holding
tone” of “Set hold tone”. For videophone calls, the still
image set for “Holding” of “Select image” is displayed.
p You can put the call on hold by closing the FOMA
phone during the call if you have set “Setting when
folded” to “Tone on”.
2
Press Oo () or d to release hold
and answer the call.
p If a videophone call is on hold, the image through your
camera is sent to the other party by pressing
Oo () or d to release hold. If you press
m ( ) to release hold, the substitute image is
sent.
p If you have set “Setting when folded” to “Tone on” and
put the call on hold by closing the FOMA phone, open
the FOMA phone or connect the Flat-plug Earphone/
Microphone with Switch (option) to answer the call.
If you connect the Flat-plug Earphone/Microphone with
Switch to answer the videophone call, the substitute
image is sent to the other party.
Information
p The caller is charged for the call even during answer-hold
(On Hold).
p If you press -h during answer-hold (On Hold), the call
will be disconnected.
Holding
Putting a Call on Hold during a Call
<>
Information
p The caller is charged for the call even while the call is on
hold.
p If a new call comes in while the current call is put on hold,
the hold (Holding) is released.