User's Manual Part 2
385
Music&Video Channel/Music Playback
Information
When the communication is disconnected during obtaining a program, re-obtaining is
automatically tried up to five times by an interval of about three minutes. When a
display for obtaining a program is shown, however, the confirmation display appears
asking whether to re-obtain the program.
The ring tone does not sound and the vibrator does not work to notify that obtaining
programs starts or is completed. When you set “Music&Video ch illum.” of
“Illumination” to “ON”, the Call/Charging indicator flickers when obtaining programs is
completed. (See page 122)
You can set up to two programs at once.
Note that a newly obtained program overwrites a saved program and you can no
longer play back that saved program afterward. To avoid overwriting, perform “Move
program” to move the program to the “Saved program” folder.
You cannot save the obtained program to the microSD card.
To set programs, you need to register the site which offers Music&Video Channel
programs to your My Menu. (See page 177)
If you have not subscribed to Music&Video Channel, select “About this service” to see
the Music&Video Channel introduction page.
When the programs could not be obtained due to “power off” or “low battery” at the
start time of program obtaining, re-obtaining is performed at night of the following day.
It may take a time to obtain programs, so fully charge the battery and operate in the
good radio wave conditions.
You cannot perform the setting operation and automatic obtaining of the program
selected on the Music&Video Channel display or the program in use.
When you cancel Music&Video Channel, the programs other than those moved by
“Move program” are deleted.
If you insert a UIM which is different from the one you used to set programs, programs
cannot be automatically obtained. Set the programs again from the Music&Video
Channel display.
When you select a service menu for Music&Video Channel and the message
“Confirm set up information?” appears, select “YES” to delete the programs that have
already been distributed. However, they may not be deleted while the distribution of
programs is halted.
If you insert the UIM of the FOMA phone that you have already set programs into
another Music&Video Channel compatible FOMA phone, the programs cannot be
obtained automatically. Select “Set program” again from the Music&Video Channel
display to automatically update the program setting on the FOMA phone, then the
programs can be obtained automatically.
1
Music&Video Channel displaySet program
Follow the instructions on the display.
You can check or cancel the set program. For details, refer to “Mobile Phone
User’s Guide [i-mode] FOMA version”.
“ ” appears on the Stand-by display when the automatic program
obtaining fails or the program is not updated even after the program
distribution date. When the automatic obtaining fails, you can manually
obtain the program.
1
Music&Video Channel displaySelect a programYES
For a partially obtained program, select “Play” to play it back.
For a program which has not been updated, select “Play” to play it back.
Check/Cancel the Set Program
Information
Even if the setting of a program is canceled, My Menu is not deleted.
Obtain a Program Manually
Information
When obtaining of a program is suspended, the part of the program obtained up to
that point is saved. To obtain remaining part, you can manually obtain it except in
some time zones. When a program has been updated or switched to another
program, obtaining starts not from the suspended point but from the beginning.
You cannot re-obtain the program whose playable deadline has expired. Such a
program cannot be updated until the next distribution date.
You may not be able to manually obtain programs depending on the time zone.