User's Manual Part 1

46
Before Using the Handset
If the date and time, Terminal Security Code, Keypad Sound, Location
Request Menu, or Character Size is not set, the Initial Setting display
appears when you turn on the power. You can set the initial settings also
from each menu function separately.
1
Turn on the powerYES
When the display for entering your Terminal Security
Code, PIN1 code, or PIN2 code appears, follow the
operation on page 45.
2
Set the date and time.
You can select “Auto time adjust ON” or “Auto time adjust OFF” for setting the time.
(See page 46)
3
Set your Terminal Security Code.
You can set your Terminal Security Code required for setting functions.
(See page 126)
1. Enter “0000”Enter your new Terminal Security Code (four to eight digits)
YES
4
Set Keypad Sound.
You can set whether to make a keypad sound. (See page 109)
5
Set Location Request Menu.
You can set whether to notify your current location for when a GPS location
provision request arrives. (See page 340)
6
Set the size of characters.
You can set the size of characters on the display at a time. (See page 123)
<Initial Setting>
Configuring Initial Setting
You can select whether to correct the time automatically or set it
manually. The time is set/displayed on the 24-hour basis.
1
mSet./ServiceClockSet time
Auto time adjust ON or Auto time adjust OFF
Auto time adjust ON
. . . . Corrects the date/time automatically. The setting is completed.
When the time cannot be corrected automatically such as when “ ” is
displayed and the date/time has not been set, the Manual Time Setting
display appears. Follow step 2 to set the date/time.
Auto time adjust OFF
. . . . Sets the date/time manually.
When “Notice call cost” is set to “ON”, you need to enter your Terminal Security
Code.
Information
When an unset function is found, the Initial Setting display for the unset function
appears each time you turn on the power.
The completed settings are valid even when total setting is interrupted by an incoming
call or canceled by pressing -h or -r midway.
When the power is automatically turned on by alarm notification, the Initial Setting
display does not appear even if there is any unset function.
When you finish the initial settings, the confirmation display appears telling that
updating software is executed automatically. This display appears only at the first
time, and after that, does not appear until you execute Reset Settings or Initialize.
+m-3-1
<Set Time>
Setting Date and Time