User's Manual Part 1
57
Voice/Videophone Calls/PushTalk
You can store up to 10 Chaku-moji messages in the Message list.
1
mSet./ServiceNW servicesChaku-moji
Create message
Highlight <Not stored> and press l()
Enter a message.
To edit a stored message, highlight it and press l().
You can enter up to 10 characters regardless of whether they are pictographs,
symbols, or full-pitch/half-pitch characters.
1
Enter a phone number
or
call up the detailed display of a Phonebook entry, redial
item, dialed call record, or received call record.
2
i
()
Chaku-moji
Do the following operations.
3
Press d or Oo().
Press l( ) to make a videophone call.
The Chaku-moji message being sent is displayed during dialing.
Store Messages
Make a Call with a Message
Create message You can create a Chaku-moji message just before dialing.
Enter a message.
You can enter up to 10 characters regardless of whether they
are pictographs, symbols, or full-pitch/half-pitch characters.
The Chaku-moji message created using this function is not
stored in the Message list.
Select message From the Message list, you can select a stored message.
Select a message.
Sent messages From the Sent Message list, you can select a Chaku-moji
message to be sent. Up to 10 sent Chaku-moji messages only
are stored in the Sent Message list. If you send the same
Chaku-moji message, the older one is deleted. When the number
of sent Chaku-moji messages exceeds 10, the messages are
deleted from the oldest one.
Select a sent message.
Up to 10 sent Chaku-moji messages are stored in Sent Messages, and
you can check for the other party’s phone number and the date/time the
Chaku-moji messages were sent. Older messages sent to the same
phone number are also retained.
In Dual Mode of 2in1, up to 10 records for Number A and Number B can be displayed
in total.
1
mSet./ServiceNW services
Chaku-mojiSent messages
. . . . Chaku-moji message successfully sent
. . . . Chaku-moji message unsuccessfully sent
. . . . . . . Chaku-moji message for Number B (only in Dual Mode of 2in1)
When the transmission result is not displayed, “ ” or “ ” is not
displayed.
Depending on the radio wave conditions, the transmission result might not be
displayed correctly.
Information
When a Chaku-moji message has arrived at the other party’s phone, “Transmission
completed” is displayed, and you are charged a transmission fee.
When a Chaku-moji message does not arrive at the other party’s phone such as when
the other party’s phone is not a Chaku-moji compatible mobile phone or the call is not
allowed by “Message disp. settings” at the receiving end, “Transmission failed” is
displayed. In this case, you are not charged a transmission fee.
Depending on the radio wave conditions, the transmission result may not be
displayed at the sending end even if a Chaku-moji message has arrived at the other
party’s phone. In this case, you are charged a transmission fee.
Even if you make a call sending a Chaku-moji message, the Chaku-moji message is
not displayed and you are not charged a transmission fee (the call is not recorded in
Received Calls at the receiving end) when the other party’s phone is out of the service
area, turned off, during Public Mode (Drive Mode), or the ring time for Record
Message Setting is set to zero seconds. Also, the transmission result is not displayed
at the sending end.
When a videophone call is not connected and automatically dialed as a voice call, the
Chaku-moji message is resent as well.
Chaku-moji does not support PushTalk.
You cannot send/receive Chaku-moji messages overseas.
Detailed Sent Message