User's Manual Part 1
68
Voice/Videophone Calls/PushTalk
You can adjust the ring volume for incoming calls and mail.
1
mSet./ServiceSoundRing volume
Select an incoming type
Use Bo to adjust the volume.
The following icons are displayed on the Stand-by display while “Ring volume” is
set to “Silent”:
: You set “Phone”, “PushTalk”, or “Videophone”.
: You set “Mail”, “Chat mail”, “MessageR”, “MessageF”, or “i-concier”.
: You set “Phone”, “PushTalk”, or “Videophone”, and set “Mail”, “Chat mail”,
“MessageR”, “MessageF”, or “i-concier”.
If you have set “Step”, the ring tone is silent for about three seconds, and then the
volume steps up every three seconds, from Level 1 through Level 6.
During ringing of a voice call or videophone call, you can adjust the ring volume
also by pressing Bo. However, you cannot adjust the ring volume in the
following cases:
・When “Ring volume” is set to “Step”
・When “Answer setting” is set to “Quick silent” and you stop the ring tone or
voice guidance
・During Manner Mode
・When a call is cut off within the ring start time specified by “Ring time”
When you adjust the earpiece volume, the sound volume during a Hands-free call or
speaker call for PushTalk is also adjusted.
+m-5-0
<Ring Volume>
Adjusting Ring Volume
Information
1
During ringingh
The FOMA terminal makes three rapid beeps for confirmation and the call is put on
answer-hold (On Hold).
The confirmation tone does not sound during Manner Mode or when “Ring
volume” is “Silent”.
The other party hears the hold tone set for “On hold tone” of “Set hold tone”. For
videophone calls, the still image set for “On hold” of “Select image” is displayed.
2
Press d or Oo( ) to release hold and answer
the call.
If “Answer setting” is set to “Any key answer”, you can release hold of voice calls
by pressing any key of 0 through 9, a, s, r, m, c, Mo, <, >,
l, or i.
If a videophone call is on hold, the image through your camera is sent to the other
party by pressing d or Oo( ) to release hold. If you press m()
to release hold, the substitute image is sent.
1
During a callOo ()
The other party hears the hold tone set for “Holding tone” of “Set hold tone”. For
videophone calls, the still image set for “Holding” of “Select image” is displayed.
You can put the call on hold by closing the FOMA terminal during the call if you
have set “Setting when closed” to “Hold”.
<On Hold>
Putting a Call on Hold when You cannot
Answer Immediately
Information
The caller is charged for the call even during answer-hold (On Hold).
If you press -h during answer-hold (On Hold), the call will be disconnected.
<Holding>
Putting a Call on Hold during a Call