User's Manual Part 2

308
i-αppli/i-Widget
You can make an i-αppli program start automatically at the set date and
time. Set the date and time for automatic start using Auto Start Time.
You can set whether to enable automatic start of i-αppli programs.
1
mi-αppliiαppli settingsAuto start setting
ON or OFF
αPower saver You can set to Power Saver Mode to decrease battery
consumption by suspending the i-αppli program temporarily
for when you close the FOMA terminal during i-αppli running.
ON or OFF
This setting is valid from when an i-αppli program starts until
it closes.
Even when this function is set to “ON”, Power Saver Mode
becomes invalid if “Power saver” that can be set for each
i-αppli program is set to “OFF”.
αVibrator You can set the vibrator operation for when an i-αppli program
is running.
Depend on system or Depend on software
Depend on system . . . . Does not work regardless of the
setting of “Vibrator”. With some
software programs, the vibrator
works.
Depend on software . . . Follows the setting of each software
program.
Check settings You can check each of “iαppli settings”.
Information
<αBacklight> <αVibrator>
With some software programs, the backlight and vibrator settings are “OFF”.
Consequently, if you set “Depend on software”, the backlight and vibrator will not
work; if you want them to work, set “Depend on system”.
Starting i-αppli Automatically
Auto Start Setting
You can set the date and time for automatic start. You can set for up to
three software programs.
1
Software listi()Auto start time
2
Put a check mark for an item to be setl()
Time interval set . . . . Starts at an interval specified by the software program. The
setting is completed.
Start time set . . . . . . . Starts at the set start time automatically.
3
Select start timeEnter the date and time to be set.
4
1 timeSelect a type of repeat.
If you select “1 time”, the automatic start is not repeated.
If you select “Weekly”, put a check mark for days of the week to be set and press
l().
5
Press l().
You can check whether a software program has started automatically
and properly. Also, you can check the information of start failure from IC
card. Up to three records of automatic start, a record of automatic start
set by i-αppli, and a record of start failure from IC card are stored.
1
mi-αppliiαppli infoAuto start info
StartO . . . . .Started automatically and properly.
StartX . . . . .Did not start automatically.
When “ ” is displayed, you can press Oo( ) to start the
software program.
Start–. . . . . .Has not started yet.
Auto Start Time
Auto Start Info