User's Manual Part 2
247
Camera
You can set the file restrictions for when you save the shot still image or
movie. The operation of attaching to i-mode mail is disabled at the
receiving end who has received the image as the first distribution.
1
Finder displayi()Storage setting
File restriction
or
Post View display in Photo Mode, Movie Mode or
Continuous Mode/Detailed display in Continuous Mode
i()File restriction
2
File unrestricted or File restricted
For Post View display for Continuous Mode, you can change the settings of the
file restriction on the checked images.
<Display size>
When “Image size” is set to a size larger than “HVGA Wide (640 x 352)”, “Fit in
display” always applies.
When “Image size” is set to “QCIF (144 x 176)” or “Sub-QCIF (96 x 128)”, the image is
enlarged two times at both lengthwise and sidewise when it is displayed in “Actual
size”.
The setting for the Finder display is reflected in the Post View display; however the
setting for the Post View display is not reflected in the Finder display.
<Common replay mode>
You cannot operate when you set “File size setting” to “Long time”.
File Restriction
Information
Information
Even when you set “File restriction” to “File restricted”, the still images or movies can
be output from the destination mobile phone by transmitting the images using infrared
communication or by copying them to the microSD card.
After saving, you can use “File restriction” on page 348 to change the settings.
When you set “File size setting” to “Long time” in Movie Mode, “File restriction”
becomes “File unrestricted”.
1
Finder displayi()Auto timerON or OFF
Enter a delay time (seconds).
Enter from “01” through “15”, in two digits.
“ ” appears on the Finder display.
If you press Oo() or 0, a confirmation tone sounds and “ ” blinks. The Call/
Charging indicator flickers every about 1 second until about 5 seconds before shooting.
From about 5 seconds before shooting, the Call/Charging indicator flickers every about
0.5 second, and the confirmation tone sounds every about 1 second. Shooting takes
place after the set delay time has elapsed.
To cancel shooting, press l() or r while the Call/Charging indicator is
flickering. Even if you cancel shooting, “Auto timer” stays set to “ON”.
You can shoot immediately by pressing Oo() or 0 before the delay time has
elapsed.
When you shoot, a confirmation tone sounds regardless of the settings such as
Manner Mode. You cannot change the sound volume for the confirmation tone.
Auto Timer
At Camera start-up OFF
When Auto Timer is set to “ON”
Information
You cannot use Auto Timer in “Manual” of Continuous Mode.
Auto Timer is set to “OFF” when shooting ends.