User's Manual Part 2
260
1Seg
By using the i-αppli Program Guide, you can select a program from the
program guide to start 1Seg or set TV Timer/Timer Recording. (See
page 302)
1
m1SegProgram guide
Press l( ) from the display of “Gガイド番組
表リモコン (G Guide Program List Remote Control)” to
watch the program currently broadcast on the selected
channel.
For details, refer to “Mobile Phone User’s Guide
[i-mode] FOMA version”.
Information
Even if “Mail ticker display” is set to “Sender+subject”, the titles are not displayed for
Messages R/F, i-mode mail messages, and SMS messages received from the parties
not stored in the Phonebook.
Even when you show the detailed Received Mail display by Multitask while you are
watching a 1Seg program, the display appears in the multiwindow.
When “Mail ticker display” is set to “OFF” and “Receiving display” is set to “Alarm
preferred” and you receive a mail message while watching a 1Seg program, the
Reception Result display appears. The mail message is shown in the multiwindow
even when you show it from the Reception Result display. However, the viewer
display does not appear and the audio from a 1Seg program is not output when you
show a mail message from the party whose mail address is not stored in the
Phonebook.
When “ ” or “ ” appears, press and hold +c for at least one second to switch to
viewer display and then operate.
<i-αppli Program Guide>
Using i-αppli Program Guide
Information
You can set the i-αppli Program Guide by “Program guide key” of “Software setting”.
When you use “Gガイド番組表リモコン (G Guide Program List Remote Control)”
for the first time, you need to do initial settings.
1Seg enables you to use the data broadcasting in addition to the video
and audio. Various information including still images/movies is available
from the site linked with TV programs.
1
Viewer display (Video Mode)
m()
Video Mode switches to Data Broadcasting Mode and
“ ” appears.
Audio from a 1Seg program is output even during Data
Broadcasting Mode.
You can display only data broadcasting when you press
c( ) in Data Broadcasting Mode. Press
c( ) to return to the former display.
2
Select an item (link).
The confirmation display appears asking whether to connect to i-mode
depending on the data broadcasting and data broadcasting site.
See page 195 for the operation while a site is displayed.
This software program is not available when the mode of 2in1 is set to B Mode.
<Data Broadcasting>
Using Data Broadcasting
Information
Information
Each time you press +m( ), Video Mode and Data Broadcasting Mode are
switched.
You cannot display the data broadcasting on the horizontal display.
You cannot enter pictographs when you enter characters on data broadcasting or
data broadcasting site.
Depending on the program, the audio might be output while the i-mode site is
displayed. However, the 1Seg video is not displayed.
Depending on the program, a tone might be output when you display the data
broadcasting or data broadcasting site. In that case, the output of the 1Seg audio
temporarily stops, and the tone of the data broadcasting is preferentially output.