User's Manual Part 2
296
i-αppli/i-Widget
Change mld./img. You can set whether to permit the i-αppli program to change
the setting for the ring tones, Stand-by display, etc. This
function is available only for i-αppli DX programs.
ON, OFF or Check every changel()
If you select “Check every change”, the confirmation display
appears each time the i-αppli program tries to change the
setting for the ring tones, Stand-by display, etc.
See P. book/hist. You can set whether to permit the i-αppli program to refer to
the Phonebook, Redial, and Received Calls. This function is
available only for i-αppli DX programs.
ON or OFFl()
View ToruCa You can set whether to permit the i-αppli program to refer to
ToruCa files. This function is available only for i-αppli DX
programs.
ON or OFFl()
Location usage You can set whether to permit the i-αppli program to use
location information. This function is available only for i-αppli
DX programs.
ON or OFFl()
Program guide key You can set the software program for the Program Guide
i-αppli that starts up from 1Seg. You can set this only for the
i-αppli DX program that links to 1Seg.
ON or OFFl()
Map setting You can set the software program used on the GPS function.
ON or OFFl()
iαppli call See page 309.
Software info You can display the software name, version, and others of the
i-αppli program.
Upgrade YES
Add desktop icon See page 31.
Delete
Delete this YES
Delete selected Put a check mark for software programs to be deleted
l()YES
Delete all Enter your Terminal Security CodeYES
Move to microSD See page 376.
Move to phone See page 376.
Power saver You can set whether to validate Power Saver Mode for each
i-αppli program for when “αPower saver” is set to “ON”.
ON or OFF
Information
<Icon info>
When you set “Icon info” to “ON” for the i-αppli Stand-by display, the icon information
for unread mail/message, battery level, Manner Mode, radio wave strength and
out-of-service area can be sent to the IP (Information Provider) over the Internet in the
same way as the Phone/Terminal and UIM ID, and can be deciphered by third parties.
When the software program needs “Icon info”, the software program might not run if
“OFF” is selected.
<Upgrade>
Depending on the software program, you can upgrade it at start.
At upgrading, the confirmation display might appear asking whether to send the
“Phone/Terminal and UIM ID. Select “YES” to start upgrading. In this case, the
“Phone/Terminal and UIM ID” is sent to the IP (Information Provider) over the Internet,
so could be deciphered by third parties. However, your phone number, address, age,
and gender are not notified to the IP (Information Provider) or others by this operation.
You cannot upgrade the mail-linked i-αppli in the following cases:
・While details of the corresponding i-αppli mail folder are displayed
・While Mail Security is set
・When Mail Security is set for the corresponding i-αppli mail folder