User's Manual Part 1

186
Mail
You can compose and send SMS messages. You can save up to 1,000
sent SMS messages including i-mode mail messages to the Outbox.
≥You can send and receive SMS messages to and from subscribers of overseas
carriers other than DOCOMO. For the countries and overseas carriers available for the
service, refer to the DOCOMO Global Service web page.
≥You can move/copy the sent SMS messages to the UIM. (See page 418)
1
l1Compose SMS
2
Select the address field1Select an item.
Phonebook . . . . . . . . . Call up a Phonebook entry and select a phone number.
Sent address . . . . . . . . Select a phone number and press Oo().
Received address. . . . Select a phone number and press Oo().
Enter address . . . . . . . Enter a phone number.
Only one address can be specified.
≥You can enter up to 21 digits (including “+”).
≥When the address is that of overseas carriers other than DOCOMO, enter “+”
(press and hold 0 for at least one second), “country/area code”, and
“destination mobile phone number” in that order. When the mobile phone number
begins with “0”, enter the phone number except for the “0”. Also, you can enter
“010”, “country/area code”, and “destination mobile phone number” in that order
to send SMS messages. (When you reply to SMS messages received from
overseas, enter “010”.)
3
Select the text field1Enter text.
≥The number of characters you can enter differs depending on the “SMS input
character”.
4
Press l().
The animation display during transmission appears and mail is sent.
<Compose SMS>
Composing and Sending SMS
SMS Composition
display
Address field
Text field
5
OK
Information
≥Depending on the radio wave conditions, the characters might not be sent
successfully to the destination.
≥When the sent mail messages exceed the maximum number of storage, they are
deleted from the oldest one. However, protected sent mail messages are not deleted.
≥You cannot compose an SMS message when sent mail messages in the Outbox are
saved to the maximum and all of them are protected, when 20 draft mail messages
are saved, or when the Draft is full.
Release the protection for sent mail messages, or send/delete draft mail messages,
and then operate again.
≥Even if “Activate” of “Caller ID notification” is set to “OFF”, the caller ID is notified to the
other party you send an SMS message to. If you attempt to send an SMS message to
the phone number headed by “184”/“186”, the confirmation display appears asking
whether to delete prefix numbers and send the mail.
≥If you set “SMS report request” to “ON”, you cannot send SMS messages to the
i-mode phone of the mova service.
≥“+” is valid only at the beginning of the address.
≥You cannot send the message to addresses that include any characters other than
numbers, “#”, “:” and “+”.
≥You cannot start a new line while editing the text.
≥The special symbols (see page 500) are replaced by half-pitch spaces.
≥Each space is counted as a character.
≥You cannot reply to the SMS message whose sender is User unset/PublicPhone/
Unavailable.
≥In B Mode of 2in1, you cannot compose SMS messages.
Function Menu of the SMS Composition Display
Send You can send the SMS message.
Go to step 5 on page 186.
Preview Before sending, you can check the address and the text contents.
≥Press l( ) to send the SMS message.