User's Manual Part 1

188
Mail
You can set whether to request an SMS report for when sending an SMS
message.
The SMS report lets you know that your SMS message was delivered to
the destination.
You can check received SMS reports in the “Inbox” folder.
1
l1SMS settings1SMS report request1ON or OFF
≥When you operate from the Function menu of the SMS Composition display, the
setting is effective only for the SMS message you are composing.
You can set the period that the SMS Center holds an SMS message sent
but unsuccessfully delivered due to the out-of-service area, etc.
1
l1SMS settings1SMS validity period
1Select a holding period.
≥If you select “None”, the stored SMS message is re-sent after a certain period of
time and deleted from the SMS Center.
≥When you operate from the Function menu of the SMS Composition display, the
setting is effective only for the SMS message you are composing.
≥When “ (dark blue)” or “ (dark blue)”, etc. are displayed, you cannot receive any
more SMS messages. Delete unnecessary mail, read unread mail, or release
protection. (Read and unprotected messages are automatically deleted from the
oldest one.)
≥You cannot use this function to receive i-mode mail or Messages R/F. Use “Check
new messages” to receive i-mode mail or Messages R/F.
<SMS Settings>
Setting SMS
SMS Report Request
Information
SMS Validity Period
You can set the characters you can enter into the text of SMS messages.
You can set to enter only half-pitch alphanumeric characters and
half-pitch symbols.
1
l1 SMS settings 1 SMS input character 1 Select an item.
Japanese (70char.) . . . You can enter full-pitch and half-pitch characters. You
cannot enter pictograms except “ ” and “ ” (see
page 496). You can enter up to 70 characters for the text.
English (160char.). . . . You can enter only half-pitch alphanumeric characters
and half-pitch symbols. You can enter up to 160
characters for the text.
≥When you operate from the Function menu of the SMS Composition display, the
setting is effective only for the SMS message you are composing.
You can set the address and “Type of number” for the SMS Center. This
setting is for getting any service other than SMS Service you currently use.
1
l1SMS settings1SMS center selection
1User setting1Enter an address
1International or Unknown
≥You can enter up to 20 half-pitch characters for the address. However, if “#” or
“:” is included, you cannot set it for “International”.
≥You can reset User Setting to “DOCOMO” by Reset1Enter your Terminal
Security Code1YES.
You can send mail messages or browse received mail messages on the
i-mode site.
≥You can use only in B Mode or Dual Mode of 2in1.
≥For details on Web mail, refer to “Mobile Phone User’s Guide [2in1]”.
1
l1Web mail
1Operate following the instructions on the display.
SMS Input Character
SMS Center Selection
※Normally, you do not need to change this setting.
<Web Mail>
Using Web Mail