User's Manual Part 1

60
Voice/Videophone Calls/PushTalk
You can store prefix numbers such as international call access codes or
“186”/“184” and add them to the phone number for dialing. You can store
up to seven prefix numbers.
1
m1Set./Service1Network setting1Prefix setting
1Highlight <Not recorded> and press l().
≥If you select a stored prefix, you can check the stored contents.
≥To delete a stored prefix, press i( ) and select “Delete this” or “Delete
all” then select “YES”. If you select “Delete all”, you need to enter your Terminal
Security Code.
2
Enter a name1Enter a prefix number.
≥You can enter a name of up to 8 full-pitch/16 half-pitch characters.
≥You can enter a prefix number of up to 16 digits. The keys for entry are limited to
0 through 9, s and a.
You can add a prefix number to the beginning of phone number when
you make a call.
1
Enter a phone number
or
call up the detailed display of a Phonebook entry, redial
item, dialed call record, or received call record.
Delete all 1Enter your Terminal Security Code1YES
Information
<Delete this> <Delete all>
≥You cannot delete the country/area code or international call access code set by
“Auto assist setting”.
<Prefix Setting>
Storing Numbers to be Added to the
Beginning of a Phone Number
Prefix Numbers
2
i()1Prefix numbers1Select a name
1d or Oo()
≥Press l( ) to make a videophone call and press p to make a PushTalk
call.
≥For making a PushTalk call, adding a prefix number such as “186” or “184” to the
beginning of the phone number is disabled.
You can set whether to regard the numbers after “:” of a phone number
as a sub-address to access the specified phones or data terminals.
≥The sub-address is a number assigned to identify each ISDN terminal connected to an
ISDN line. It is also used for selecting contents on “V-live”.
1
m1Set./Service1Other settings
1Sub-address setting1ON or OFF
You can set an alarm that sounds until a voice call, videophone call, or
PushTalk communication is reconnected after disconnected owing to
bad radio wave conditions.
1
m1Set./Service1Talk1Reconnect signal
1Select an alarm.
<Sub-address Setting>
Making a Call Specifying a Sub-address
Information
≥Even if you set “Sub-address setting” to “ON”, “:” at the top of phone numbers and
“:” immediately after the prefix number or “186”/“184” are not regarded as
sub-address mark-off symbols.
+m-7-7
<Reconnect Signal>
Setting Alarm for Reconnecting