User's Manual Part 1

66
Voice/Videophone Calls/PushTalk
You can adjust the ring volume for incoming calls and mail.
1
m1Set./Service1Sound1Ring volume
1Select an incoming type
1Use Bo to adjust the volume.
≥The following icons are displayed on the Stand-by display while “Ring volume” is
set to “Silent”:
: Set for “Phone”, “PushTalk”, or “Videophone”.
: Set for “Mail”, “Chat mail”, “MessageR”, “MessageF”, or “i-concier”.
: Set for “Phone”, “PushTalk”, or “Videophone”, and for “Mail”, “Chat mail”,
“MessageR”, “MessageF”, or “i-concier”.
≥If you have set “Step”, the ring tone is silent for about three seconds, and then the
volume steps up every three seconds, from Level 1 through Level 6.
≥While the phone is ringing for a voice call or videophone call, you can adjust the
ring volume by pressing Bo. However, you cannot adjust the ring volume in the
following cases:
・When “Ring volume” is set to “Step”
・When “Answer setting” is set to “Quick silent” and you stop the ring tone or
voice guidance
・During Manner Mode
・When a call is cut off within the ring start time specified by “Ring time”
+m-5-0
<Ring Volume>
Adjusting Ring Volume
1
During ringing1h
The FOMA terminal makes three rapid beeps for confirmation and the call is put on
answer-hold (On Hold).
≥The confirmation tone does not sound during Manner Mode or when “Ring
volume” is “Silent”.
≥The other party hears the hold tone set for “On hold tone” of “Set hold tone”. For
videophone calls, the still image set for “On hold” of “Select image” is displayed.
2
Press d or Oo( ) to release hold and answer
the call.
≥If “Answer setting” is set to “Any key answer”, you can release hold of voice calls
by pressing any key of 0 through 9, a, s, r, m, c, Mo, <, >,
l, or i.
≥If a videophone call is on hold, the image through your camera is sent to the other
party by pressing d or Oo( ) to release hold. If you press m()
to release hold, the substitute image is sent.
1
During a call1Oo ()
≥The other party hears the hold tone set for “Holding tone” of “Set hold tone”. For
videophone calls, the still image set for “Holding” of “Select image” is displayed.
≥You can put the call on hold by closing the FOMA terminal during the call if you
have set “Setting when closed” to “Hold”.
<On Hold>
Putting a Call on Hold when You cannot
Answer Immediately
Information
≥The caller is charged for the call even during answer-hold (On Hold).
≥If you press -h during answer-hold (On Hold), the call will be disconnected.
<Holding>
Putting a Call on Hold during a Call