User's Manual Part 1

67
Voice/Videophone Calls/PushTalk
2
Press d or Oo( ) to release hold and answer
the call.
≥When you have put a voice call on hold, you can release the hold also by
pressing r.
≥If a videophone call is on hold, the image through your camera is sent to the other
party by pressing d or Oo( ) to release hold. If you press m()
to release hold, the substitute image is sent.
≥You can release hold also by opening the FOMA terminal.
You can set the guidance the other party hears during on hold.
1
m1Set./Service1Talk1Set hold tone
1On hold tone or Holding tone1Select a hold tone.
Tone 1/2 . . .The caller hears the pre-installed guidance in Japanese.
RHAPSODY ON A THEME OF
. . . . . . . . . . .The caller hears the melody. You can set this for “Holding tone” only.
Voice announce
. . . . . . . . . . .The caller hears the sound recorded by “Voice announce”. If it has
not been recorded, this is not displayed.
≥Press l( ) to play back a hold tone. Press r to end the demo
playback.
Information
≥The caller is charged for the call even while the call is on hold.
≥If a new call comes in while the current call is put on hold, the hold (Holding) is
released.
<Set Hold Tone>
Setting Hold Tone
Public Mode is an auto-answer service that puts importance on manners
in public spaces. Once you activate Public Mode, the guidance is played
back telling that you cannot answer the call as you are currently driving
or in a place (a train, bus, movie theater, etc.) where you should refrain
from answering the call. Then the call is disconnected.
≥Voice Mail Service
※1
, Call Forwarding Service
※1
, and Caller ID Display Request
Service
※2
work taking priority over Public Mode.
※1If a ring time is set to other than 0 seconds for incoming calls, the service works
after the Public Mode guidance.
※2When the other party notifies you of the phone number, Public Mode works.
≥Public Mode does not work to the calls from the party set to be rejected by Nuisance
Call Blocking Service.
1
Press and hold a for at least one second.
Public Mode is activated and “ ” is displayed.
When a call comes in, the guidance “The person you are calling is currently driving
or in an area where cell phone should not be used. Please try again later.” is played
back for incoming calls.
≥To deactivate Public Mode, perform the same operation. Then, Public Mode is
deactivated and “ ” disappears.
Using Public Mode
Using Public Mode (Drive Mode)
Information
≥You can activate/deactivate Public Mode only from the Stand-by display. You can
activate/deactivate Public Mode even when “ ” is displayed.
≥You can make calls as usual even during Public Mode.
≥If you make an emergency call at 110/119/118, Public Mode is released.
≥When Public Mode and Manner Mode are activated simultaneously, Public Mode has
priority.
≥If a “User unset” call comes in while “Caller ID request” is set to “Activate”, the Caller
ID Request guidance is played back. (The Public Mode guidance is not played back.)
≥You cannot use this function during data communication.