User's Manual Part 1

75
Voice/Videophone Calls/PushTalk
You can set an image to be sent to the other party.
1
m1Set./Service1Videophone1Select image
1Select an item.
On hold . . . . . Sets an image for during answer-hold (On hold).
Holding . . . . . Sets an image for while a call is on hold (Holding).
Substitute image
. . . . . . . . . . . . Sets a substitute image (still image or Chara-den) for when the
camera is off.
Record message
. . . . . . . . . . . . Sets an image while recording a record message.
Preparing . . . Sets an image for while playing back an answer message.
Movie memo
. . . . . . . . . . . . Sets an image for while recording a movie memo.
2
Select an image.
Pre-installed . . . For sending a pre-installed still image to the other party.
Original . . . . . . . For sending an appropriate message with a still image stored
using “Set display”.
Chara-den. . . . . For sending a Chara-den image selected by “Substitute image”
from the Function menu while a Chara-den image is displayed.
(See page 72)
(Displayed only when “Substitute image” has been selected in
step 1.)
≥Press l( ) to play back a demo to check the still image or Chara-den
image.
≥To change the setting of “Original” or “Chara-den”, press i( ), select
“Change setting”, then select a still image or Chara-den image. If you have
selected “Original”, select a still image after selecting a folder. However, you
cannot select a still image larger than Stand-by (480 x 854) size.
<Select Image>
Changing Image Displays for Videophone
Calls
Information
≥Even if you delete the still image selected from “Original”, that still image is displayed
to the other party. To change, set by “Change setting” or “Set display”.
You can set an image to be sent to the other party for making a
videophone call.
1
Enter a phone number
or
call up the detailed display of a Phonebook entry, redial
item, dialed call record, or received call record.
2
i()1Select image1Me or Chara-den
≥The setting is completed when you select “Me”.
≥To cancel the setting by call, select “Release”. The setting is completed.
3
Select a Chara-den image.
If a videophone call cannot be connected, it will be automatically redialed
as a voice call.
1
m1Set./Service1Videophone1Voice call auto redial
1ON or OFF
Set by Call
<Voice Call Auto Redial>
Redialing as a Voice Call when a
Videophone Call cannot be Connected
Information
≥The charges for calls once switched to voice calls are billed at the rates for the voice
calls.
≥Voice Call Auto Redial does not work when a videophone call cannot be connected
such as when the line is busy or the other party’s phone is in Public Mode (Drive
Mode). However, Voice Call Auto Redial works when you make a videophone call to a
phone that does not support the videophone function.