User's Manual Part 3

466
Overseas Use
You can specify the priority order of carriers you are connected to for
when “Network search mode” is set to “Auto”. You can store up to 20
carriers.
1
m1Set./Service1Network setting1Int’l roaming
1PLMN setting
≥You can select the stored carrier to check the stored contents.
2
i()1PLMN list select
≥To search for a carrier by a name of country/area, press l( ) and select
a country/area name. You can search also by pressing l( ) again from
the Country/Area list and entering a country/area name.
3
Select a carrier1Oo()1Select a network type
1l()1YES
<PLMN Setting>
Setting a Telecommunication Carrier to
Preferentially Connect to
Function Menu while PLMN Setting is Displayed
Set VPLMN to
UPLMN
You can store the carrier you are currently connected to.
1l()1YES
PLMN list select See “Setting a Telecommunication Carrier to Preferentially
Connect to” on page 466.
PLMN manual
select
You can store a carrier by entering a country/area code and
operator code. You can store carriers not found in the list.
1Enter a country/area code (3 digits) and operator code (2
to 3 digits)1Select a network type1l()1YES
Change priority 1Select a number to change to1l() 1YES
Delete this 1YES1l()1YES
Delete all 1YES1l()1YES
You can select whether to display, on the Stand-by display, the name of
the carrier you are currently connected to.
1
m1Set./Service1Network setting1Int’l roaming
1Display operator name1Display ON or Display OFF
The carrier’s name is displayed on the Stand-by display.
However, when you use the “DOCOMO” network, the carrier is
not displayed.
You can display whether the carrier you are currently connecting to
supports the circuit switching (CS)
※1
and packet switching (PS)
※2
.
※1 The communication system used for voice calls, videophone calls, SMS, etc.
※2 The communication system used for i-mode, i-mode mail, etc.
1
m1Set./Service1Network setting1Status in the area
Information
≥When the “DOCOMO” network is available, you are preferentially connected to it
regardless of this setting.
≥This setting is stored on the UIM.
≥You cannot set this function if the UIM is not inserted.
<Display Operator Name>
Displaying a Carrier Name on the Stand-by
Display
When you set to “Display ON”
<Status in the Area>
Confirming a Communication System
Carrier’s name