User's Manual Part 3

530
Appendix/Troubleshooting
You can set whether to update the pattern data inside your FOMA
terminal when the pattern data is created anew.
1
m1Set./Service1Lock/Security1Scanning function
1Set auto-update1ON or OFF
2
YES1OK
≥When you select “ON” in step 1, the confirmation display appears telling that your
mobile phone information is sent at auto-update.
≥To cancel during i-mode connection, select “Cancel”.
■About the display for scanned problem elements
A warning display appears when problematic data
is found. Select “Detail” from the warning display to
show the name of the problem element.
≥When six or more problem elements are found, the sixth and
later problem element names are omitted.
≥“Detail” might not appear depending on the detected problem
element.
Update Pattern Data Automatically <Set Auto-update>
Information
≥When setting auto-update or updating automatically, the proper information about
your FOMA terminal (model name, serial number, etc.) is automatically sent to the
server (DOCOMO-managed server for the scanning function). We at DOCOMO
never use the sent information for other purposes than for the scanning function.
≥When auto-update is completed, the notification icon of “ ” (Update completed)
appears on the Stand-by display. If it is failed, “ ” (Pattern update failed) appears.
Select “ ” to display the update result.
Displays for Scanning Result
■The displays for scanning result
≥The alert displays for when displaying i-mode mail messages or SMS messages may
differ from the ones above.
1
m1Set./Service1Lock/Security1Scanning function
1Version
Alert level 0 Alert level 1 Alert level 2
OK.....Continues the
operation.
YES.....Stops and ends the
operation.
NO ......Continues the
operation.
OK.....Stops and ends the
operation.
Alert level 3 Alert level 4
YES.....Deletes the data
and ends the
operation.
NO.......Stops and ends the
operation.
OK.....Deletes the data and
ends the operation.
Check Pattern Data Version <Version>