User's Manual Part 3

334
Map/GPS Function
You can provide your location information on the request from others.
Depending on the service you use, you need to set GPS service settings
beforehand. (See page 336) Also, you need to set “Location request set.”
to the setting to permit the location provision beforehand.
<When the setting by service is “毎回確認 (Check every time)”>
1
When a location provision request
arrives1YES or NO
YES . . . . Measures the current location and sends the
location information.
NO . . . . . Rejects to provide the location information.
≥If no keys are pressed for about 20 seconds, the former
display returns without providing your current location.
<When the setting by service is “許可 (Accept)”>
1
When a location provision request
arrives1OK
≥When you select “OK” or about three seconds elapse,
the current location provision starts.
≥The information about where to provide might not be
displayed.
≥Press r to stop providing information. However, your
location information might be sent depending on the
timing.
<Provide Location>
Providing Location Information on Request
Information
≥If no keys are pressed for about 15 seconds from the Position Location Result display
or the Failure display, the former display returns.
≥To use “imadoco search”, you need to trace from iMenu → “お客様サポート(User
Support)” → “各種設定（確認・変更・利用） [Settings (Confirmation/Change/Use)]”
→ “その他サービス設定・確認(Other Service Settings/Confirmation)”→ to set
“位置情報利用設定（イマドコサーチ設定） [Location Information Usage Setting
(imadoco search Setting)]”.
≥To use Provide Location, you might need to subscribe to a service provider which
supports the Provider Location function or to pay the service fee.
≥Even when you send your location information, it might not be delivered to the service
provider depending on the radio wave conditions.
≥In the following cases, the display of location provision request is not shown but the
request is rejected:
・When “Location request set.” is set to “OFF”.
・When you receive a location provision request from a party not stored in the
Phonebook while “Location request set.” is set to “Reject numbers unset”.
・When you receive a location provision request outside the validity period set by
“Location request set.”.
≥When you set, by GPS service settings, the location provision request to be checked
every time, the location information is not provided on the location provision request
during Public Mode (Drive Mode).
≥When you set, by GPS service settings, the location provision request to be accepted,
the location information is provided with a display during Public Mode (Drive Mode)
but the positioning ring tone, vibrator, and illumination do not work.
≥When you are requested to provide your location information from the party using
“imadoco kantan search”, the confirmation display appears asking whether to send
the current location information each time you receive a request. Select “YES” to
immediately send the rough position location result. After selecting “YES”, the GPS
Measuring display appears and the precise position location result is notified after
GPS measuring. The rough position location result is notified even if you suspend the
location provision during GPS measuring. In this case, it is recorded in Location
History but the location information is not displayed.
≥Regardless of the mode of 2in1, the location information can be searched for Number
A only.
When the other party searches you by your Number B, your current location is not
provided and the searcher is notified that the search has failed.
≥A fee is not charged for using the Provide Location function.
≥For using the service, refer to the information on your service provider or the
DOCOMO website.
Information