User's Manual Part 3

385
Data Management
2
Receive1YES
≥When you receive Phonebook entries in which phone numbers are stored, the
confirmation display appears asking whether to store them also in the PushTalk
Phonebook.
≥The confirmation display appears asking whether to continue receiving after
receiving one data file. When you received multiple files, select “YES”.
By using infrared rays, you can collectively send/receive data files.
To send all data files, enter a session number (any four-digit number).
The receiving end needs to enter the same session number.
■Notes on sending/receiving all data files
≥Receiving all data files at a time deletes and overwrites all the stored data files
including secret or protected data files. The data file you have stored in “Secret mode”
is deleted as well. Check that no important data file is stored before receiving all data
files.
However, Decome-Anime templates, files in Data Box, and ToruCa files are
additionally stored without deleting the files at the receiving end.
≥If you send all Phonebook entries, the “Own number” data is also sent. All the data of
“Own number” at the receiving end is overwritten except the own number. Mail address
is also overwritten by sender’s address, so change it at the receiving end.
≥Even if you send all Phonebook entries, PushTalk Phonebook entries are also sent.
Information of voice dial entries are not sent.
≥The Phonebook entries stored as secret data are sent not only during Secret Mode but
also any other time. The sent secret data is stored as secret data at the receiving end,
too.
≥The group names in the Phonebook you have received are stored, so the data set in
“Group setting” is also overwritten.
≥Note that the schedule events at the receiving end are all deleted if you send all ToDo
items to the phone that does not support ToDo.
≥You can send/receive the protected sent/received mail messages.
≥When any unsupported data file is included, receiving might be interrupted.
Information
≥When you receive an instruction for starting a software program, and you have
already downloaded a compatible software program, that software program starts. If
you have not put a check mark for “Ir iαppli To” of “Set iαppli To”, the software
program does not start up automatically.
Sending/Receiving All Data
1
Display of the data file to be sent1i()
1Send all Ir data1Enter your Terminal Security Code.
≥To send the Phonebook entries, select “Send Ir/ trans/BT” → “Send Ir data”
from the Function menu and select “Send all phonebook”.
≥To send schedule events from Schedule list or Detailed Schedule display, select
“Ir/ transmission” → “Send Ir data” from the Function menu and select “Send
all”.
≥To send mail messages, Decome-Anime templates, ToruCa files or bookmarks,
and to send schedule events from Calendar display, select “Ir/ transmission”
from the Function menu and select “Send all Ir data”.
≥When you send data files in Data Box, the confirmation display appears telling
that the files you cannot send are contained. To proceed sending, select “YES”.
2
Enter the session number1YES
≥Enter any four-digit number as the session number.
1
m1LifeKit1Receive Ir data
≥You can paste the Ir data receiving function to the desktop. (See page 31)
2
Receive all1Enter your Terminal Security Code
1Enter the same session number as that entered at the
sending end1YES1YES
Send All Data
+m-7-9
Receive All Data
Information
≥When you receive Phonebook entries in which still images are stored or mail to which
files are attached, and the multiple same still images or files are found, only one image
or file is stored.