User's Manual Part 3

400
Convenient Functions
Multiaccess enables you to simultaneously connect to three lines; a
voice call, packet communication, and SMS.
To switch the displays, press and hold x for at least one second; or
press x to switch from TASK MENU. (See page 402)
See page 503 for details on combination of Multiaccess.
You can make a voice call without disconnecting i-mode or packet
communication.
1
During i-mode or packet communication1x
1Stand-by display
2
Make a call.
≥If you make a videophone call during i-mode, i-mode is disconnected and the
videophone call is made.
After you finish the videophone call, the i-mode display returns.
<Multiaccess>
Multiaccess
Voice call Single line
i-mode, i-αppli, i-mode mail, packet communication via PC Single line
SMS Single line
Information
≥You are charged a fee for each line during Multiaccess.
Make a Voice Call during i-mode or during Packet
Communication
You can receive a voice call without disconnecting i-mode or packet
communication.
1
The Call Receiving display appears when a call comes in
1Press d to answer the call.
≥To return to the display for i-mode or packet communication without answering
the call, press and hold x for at least one second. Press and hold x for at least
one second again to return to the Call Receiving display.
The caller hears not a message but a ringback tone.
You can use i-mode, send/receive i-mode mail, etc. without
disconnecting a voice call.
1
During a voice call1x1m()
Select an icon to operate each function.
Receive a Voice Call during i-mode or during Packet
Communication
Use Communication during Voice Call
Information
≥When a mail message or Message R/F comes in during a call, the ring tone does not
sound and incoming illumination does not flicker regardless of the “Receiving display”
setting.
≥A ring tone sounds and the Receiving Result display appears when “Receiving
display” is set to “Alarm preferred” except for the following cases:
･During a call ･While the camera is activated
･While you are watching a 1Seg program (when “Mail ticker display” is set to other
than “OFF”)
･When an i-αppli program set for the Stand-by display is running as an ordinary
i-αppli program
≥When you perform packet communication via a personal computer, make a call-out
operation from the personal computer during a voice call.