User's Manual Part 1
56
Voice/Videophone Calls
You can set how your FOMA terminal works for incoming Chaku-moji
messages for when “Setting when opened” is set to “Answer”.
1
mSet./ServiceNW servicesChaku-moji
Prefer Chaku-mojiON or OFF
ON . . . . Does not answer by opening the FOMA terminal during ringing, so you
can check a Chaku-moji message.
OFF . . . Answers by opening the FOMA terminal while it is ringing.
Each time you dial out, you can set whether to notify your caller ID.
1
Enter a phone number
or
call up the detailed display of a Phonebook entry, redial
item, dialed call record, or received call record.
2
i()Notify caller ID
Don’t notify or Notify caller
To release “Notify caller ID”, select “Cancel prefix”. Whether to notify or not
follows the setting for “Activate/Deactivate” of “Caller ID notification”.
You can select whether to notify the other party of your phone number
also by entering “186”/“184” before the other party’s phone number.
Prefer Chaku-moji
<186/184>
Setting Caller ID to Send/Not to Send for
Each Call
Set Caller ID Notification when Making a Call
Set “Notify/Not Notify” by Entering “186/184”
1
186→Destination phone numberd or Oo()
Press l( ) to make a videophone call.
1
184→Destination phone numberd or Oo()
Press l( ) to make a videophone call.
You can send touch-tone signals from your FOMA terminal to use
services such as reserving tickets, checking bank balance, etc.
You need to store a number string to be sent as a touch-tone signal in the
Pause Dial list. If you have inserted a pause (p), you can send a number
string breaking at the point where the pause is inserted.
1
mSet./Service
Other settings
Pause dial
l
()
When a number string is already stored, it is displayed.
To delete a stored pause dial, press i( ) and select “Delete”, then select
“YES”.
To notify your caller ID
Not to notify your caller ID
Information
When you make a call and hear the guidance requesting your caller ID (see
page 420), follow the steps of “To notify your caller ID” to enter “186” and redial.
You cannot set “Caller ID notification” while “ ” is displayed.
+m-8-4
<Pause Dial>
Sending Touch-tone Signals
Store Pause Dial