Panasonic Installation Manual

ManualsBrandsPanasonic Ventilation ManualsFansPanasonic WhisperRecessed LED Bathroom Fan with LED Light 80 CFM

ModelNo.FV-08VRE2

READ AND SAVE THESE INSTRUCTIONS

Thank you for purchasing this Panasonic product.

Please read these instructions carefully before attempting to install, operate or service the Panasonic

product. Failure to comply with instructions could result in personal injury or property damage.

Please explain to users how to operate and maintain the product after the installation, and this booklet

should be presented to users.

Please retain this booklet for future reference.

INSTALLATION INSTRUCTIONS

Ventilating Fan

2 3

3 4

5 7

BACK COVER

COMPATIBLE DIMMERS

(NOT SUPPLIED)

GENERAL SAFETY INFORMATION

DESCRIPTION

CONTENTS

UNPACKING

SUPPLIED ACCESSORIES

DIMENSIONS

WIRING DIAGRAM

INSTALLATION

(BETWEEN JOISTS MOUNTING)

MAINTENANCE (CLEANING)

MAINTENANCE

(REPLACEMENT OF LED LAMP)

PRACTICAL GUIDE TO

INSTALLATION

SPECIFICATIONS

PRODUCT SERVICE

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Ventilating Fan Model No.
PAGE 2
GENERAL SAFETY INFORMATION For your safety To reduce the risk of injury, loss of life, electric shock, fire, malfunction, and damage to equipment or property, always observe the following safety precautions. Explanation of symbol word panels The following symbol word panels are used to classify and describe the level of hazard, injury, and property damage caused when the denotation is disregarded and improper use is performed.
PAGE 3
GENERAL SAFETY INFORMATION CONTINUED WARNING This product must be properly grounded. CAUTION Do not install this ventilating fan where interior room temperature may exceed 104 °F (40 °C). Make sure that the electric service supply voltage is AC 120 V, 60 HZ. Prohibited Extreme bending Prohibited Bend repeatedly Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the Occupation Safety and Health Act (OSHA).
PAGE 4
DESCRIPTION CONTINUED Warning: This equipment must be installed by qualified person in accordance with the provided installation instructions; and all applicable codes and standards. Also, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
PAGE 5
WIRING DIAGRAM Fan body Junction box LED lamp White White Neutral Black Black Live White White Neutral Black Black Live Power Supply AC 120 V 60 Hz Red Capacitor White Motor White Black (114 °C Fuse in Motor) Green Thermally protected Power Supply AC 120 V 60 Hz Earth ground Green INSTALLATION (BETWEEN JOISTS MOUNTING) IMPORTANT Remove the tape from damper and adaptor before installation.
PAGE 6
INSTALLATION (BETWEEN JOISTS MOUNTING) CONTINUED 5. Hang the fan body down from the four long screws, and adjust the suspension brackets if necessary. Then, tighten the four long screws up. And that, fix the other four long screws (ST4.2X20) to other holes. Make sure the fan body is level and square with the joists. (Fig. 4) 2-screws (ST4.2X6) 2-screws (ST4.2X18) Suitable screw fixing positions 6. Tighten the two screws (ST4.2X6) up (Except that the spacing is 12 inches between joists.).
PAGE 7
INSTALLATION (BETWEEN JOISTS MOUNTING) CONTINUED 13. Insert the mounting springs into the slot as shown in the figure and attach the trim ring to the fan body. (Fig. 9) 2-Mounting springs 2-Slots 1 2 Trim ring Fig. 9 MAINTENANCE (CLEANING) WARNING 2-Mounting springs Ceiling Disconnect power source before working on unit. Routine maintenance must be done every year. CAUTION Trim ring Never use gasoline, benzene, thinner or any other such chemicals for cleaning the ventilating fan.
PAGE 8
PRACTICAL GUIDE TO INSTALLATION Properly insulate the area around the fan to 6 minimize building heat loss and gain. (Fig.15) Loose fill or batt insulation can be placed mastic or approved foil directly over the fan housing in the attic. Our faced tape. fans and fan/light combination units do not create excessive heat that is a common problem with recessed light fixtures or some competitor’s fan/light combination.