user manual

50
SETUP for PORTRAIT
Press to select VIEWING AREA or LOCATION.
Press to select each function.
Notes:
• For HD signal videos, the “VIEWING AREA” is set at “16:9”,
and cannot be changed.
HD signal: 1125 (1080) / 60i • 50i • 60p • 50p • 24p • 25p • 30p
• 24sF, 750 (720) / 60p • 50p, 1250 (1080) / 50i
• When “VIEWING AREA”is “16:9”, the aspect mode is set to “FULL”.
5
Press to select VIDEO WALL UNIFORMITY.
Press to select “OFF” , “ON”.
Reduces the peak of brightness for each display to enable as uniform display as possible.
The brightness depends on
each display’s setting.
The brightness difference
is minimized.
OFF ON
Note:
I f you set VIDEO WALL UNIFORMITY to ON,
the following menus will be unavailable and
these settings will be fi xed to the initial values.
PICTURE menu: COLOR, TINT, INPUT
LEVEL (ADVANCED
SETTINGS)
VIDEO WALL UNIFORMITY
OFF
PORTRAIT SETUP
SEAM HIDES VIDEO
OFF
1
OFF
VIDEO WALL UNIFORMITY
VIEWING AREA
LOCATION
16:9
PORTRAIT SETUP
OFF
PORTRAIT SETUP
SEAM HIDES VIDEO
OFF
1
OFF
VIDEO WALL UNIFORMITY
VIEWING AREA
LOCATION
16:9
PORTRAIT SETUP
4
VIEWING AREA : Set a mode of image division for PORTRAIT function.
LOCATION: Set a location of image to be displayed for PORTRAIT function.
VIEWING AREA / LOCATION
When PORTRAIT SETUP “ON”:
Display the image of the selected LOCATION.
When PORTRAIT SETUP is “OFF”:
Represent an area of the selected LOCATION at a normal
brightness and darken the rest of it.
LOCATION setting
VIEWING AREA and LOCATION
The mode of image division and the LOCATION by setting of VIEWING AREA is as follows.
LOCATION 1 LOCATION 2 LOCATION 3
LOCATION 1 LOCATION 2 LOCATION 3
VIEWING AREA: 4:3
Suitable to display FULL images. NORMAL
(4:3) images extend transversely.
Both right and left sides of the image are
cut by 48 dots.
VIEWING AREA: 16:9
4:3 images are displayed without changing
aspect ratio.
Although the images of each LOCATION
overlap, you can adjust POS./SIZE to display
the image normally. (see page 26)
Undisplayed area (48 dots)